We construct a new seismic model for central and West Antarctica by jointly inverting Rayleigh wave phase and group velocities along with P wave receiver functions. Ambient noise tomography exploiting data from more than 200 seismic stations deployed over the past 18 years is used to construct Rayleigh wave phase and group velocity dispersion maps. Comparison between the ambient noise phase velocity maps with those constructed using teleseismic earthquakes confirms the accuracy of both results. These maps, together with P receiver function waveforms, are used to construct a new 3‐D shear velocity (Vs) model for the crust and uppermost mantle using a Bayesian Monte Carlo algorithm. The new 3‐D seismic model shows the dichotomy of the tectonically active West Antarctica (WANT) and the stable and ancient East Antarctica (EANT). In WANT, the model exhibits a slow uppermost mantle along the Transantarctic Mountains (TAMs) front, interpreted as the thermal effect from Cenozoic rifting. Beneath the southern TAMs, the slow uppermost mantle extends horizontally beneath the traditionally recognized EANT, hypothesized to be associated with lithospheric delamination. Thin crust and lithosphere observed along the Amundsen Sea coast and extending into the interior suggest involvement of these areas in Cenozoic rifting. EANT, with its relatively thick and cold crust and lithosphere marked by high Vs, displays a slower Vs anomaly beneath the Gamburtsev Subglacial Mountains in the uppermost mantle, which we hypothesize may be the signature of a compositionally anomalous body, perhaps remnant from a continental collision.

P‐to‐S receiver functions (PRFs) from the Polar Earth Observing Network (POLENET) GPS and seismic leg of POLENET spanning West Antarctica and the Transantarctic Mountains deployment of seismographic stations provide new estimates of crustal thickness across West Antarctica, including the West Antarctic Rift System (WARS), Marie Byrd Land (MBL) dome, and the Transantarctic Mountains (TAM) margin. We show that complications arising from ice sheet multiples can be effectively managed and further information concerning low‐velocity subglacial sediment thickness may be determined, via top‐down utilization of synthetic receiver function models. We combine shallow structure constraints with the response of deeper layers using a regularized Markov chain Monte Carlo methodology to constrain bulk crustal properties. Crustal thickness estimates range from 17.0±4 km at Fishtail Point in the western WARS to 45±5 km at Lonewolf Nunataks in the TAM. Symmetric regions of crustal thinning observed in a transect deployment across the West Antarctic Ice Sheet correlate with deep subice basins, consistent with pure shear crustal necking under past localized extension. Subglacial sediment deposit thicknesses generally correlate with trough/dome expectations, with the thickest inferred subice low‐velocity sediment estimated as ∼0.4 km within the Bentley Subglacial Trench. Inverted PRFs from this study and other published crustal estimates are combined with ambient noise surface wave constraints to generate a crustal thickness map for West Antarctica south of 75°S. Observations are consistent with isostatic crustal compensation across the central WARS but indicate significant mantle compensation across the TAM, Ellsworth Block, MBL dome, and eastern and western sectors of thinnest WARS crust, consistent with low density and likely dynamic, low‐viscosity high‐temperature mantle.

The seismic velocity structure of Antarctica is important, both as a constraint on the tectonic history of the continent and for understanding solid Earth interactions with the ice sheet. We use Rayleigh wave array analysis methods applied to teleseismic data from recent temporary broadband seismograph deployments to image the upper mantle structure of central and West Antarctica. Phase velocity maps are determined using a two–plane wave tomography method and are inverted for shear velocity using a Monte Carlo approach to estimate three‐dimensional velocity structure. Results illuminate the structural dichotomy between the East Antarctic Craton and West Antarctica, with West Antarctica showing thinner crust and slower upper mantle velocity. West Antarctica is characterized by a 70–100 km thick lithosphere, underlain by a low‐velocity zone to depths of at least 200 km. The slowest anomalies are beneath Ross Island and the Marie Byrd Land dome and are interpreted as upper mantle thermal anomalies possibly due to mantle plumes. The central Transantarctic Mountains are marked by an uppermost mantle slow‐velocity anomaly, suggesting that the topography is thermally supported. The presence of thin, higher‐velocity lithosphere to depths of about 70 km beneath the West Antarctic Rift System limits estimates of the regionally averaged heat flow to less than 90 mW/m2. The Ellsworth‐Whitmore block is underlain by mantle with velocities that are intermediate between those of the West Antarctic Rift System and the East Antarctic Craton. We interpret this province as Precambrian continental lithosphere that has been altered by Phanerozoic tectonic and magmatic activity.

Abstract. Thermal models of collisional orogens generally predict temperature structures that are much cooler than those recovered by thermobarometric studies. Here we demonstrate that hightemperature, low-pressure metamorphism and the development of inverted geotherms within collisional belts may be the result of accretion and erosion acting on crust enriched with heatproducing elements. A new two-dimensional finite difference model, described here, incorporates the subduction of lithosphere with heat-producing material in the upper crust, accretion of crustal material from the subducting plate to the upper plate, and surface erosion of the upper plate. These processes result in the development of a wedge of heat-producing material within the upper plate.

Previously developed continental-scale surface wave models for Antarctica provide only broad interpretations of the mantle structure, and the best resolved features in recent regional-scale seismic models are restricted above ~300-400 km depth. We have developed the first continental-scale P-wave velocity model beneath Antarctica using an adaptively parameterized tomography approach that includes data from many new seismic networks. Our model shows considerable, previously unrecognized mantle heterogeneity, especially beneath West Antarctica. A pronounced slow velocity anomaly extends between Ross Island and Victoria Land, further grid south than previous studies indicate. However, at least for mantle depths  ~200 km, this anomaly does not extend grid north along the Transantarctic Mountains (TAMs) and beneath the West Antarctic Rift System. The boundary between these slow velocities and fast velocities underlying East Antarctica is ~100-150 km beneath the front of the TAMs, consistent with flexural uplift models. The lateral extent of the low velocity anomaly is best explained by focused, rift-related decompression melting. In West Antarctica, Marie Byrd Land is underlain by a deep (~800 km) low velocity anomaly. Synthetic tests illustrate that the low velocities also extend laterally below the transition zone, consistent with a mantle plume ponded below the 660 km discontinuity. The slow anomalies beneath Ross Island and Marie Byrd Land are separate features, highlighting the heterogeneous upper mantle of West Antarctica.