No abstract

Ultrasonic sensors are often used to adjust spray volume by allowing the calculation of the crown volume of tree crops. The special conditions of the olive tree require the use of long-range sensors, which are less accurate and faster than the most commonly used sensors. The main objectives of the study were to determine the suitability of the sensor in terms of sound cone determination, angle errors, crosstalk errors and field measurements. Different laboratory tests were performed to check the suitability of a commercial long-range ultrasonic sensor, as were the experimental determination of the sound cone diameter at several distances for several target materials, the determination of the influence of the angle of incidence of the sound wave on the target and distance on the accuracy of measurements for several materials and the determination of the importance of the errors due to interference between sensors for different sensor spacings and distances for two different materials. Furthermore, sensor accuracy was tested under real field conditions. The results show that the studied sensor is appropriate for olive trees because the sound cone is narrower for an olive tree than for the other studied materials, the olive tree canopy does not have a large influence on the sensor accuracy with respect to distance and angle, the interference errors are insignificant for high sensor spacings and the sensor's field distance measurements were deemed sufficiently accurate.

No abstract

Precision spraying relies on the response of the spraying equipment to the features of the targeted canopy. PWM technology manages the flow rate using a set of electronically actuated solenoid valves to regulate flow rate at the nozzle level. Previous studies have found that PWM systems may deliver incorrect flow rates. The objective of the present study was to characterize the performance of a commercial blast sprayer modified with pulse-width-modulated nozzles under laboratory conditions, as a preliminary step before its further field validation. Four different duty cycles (25 percent, 50 percent, 75 percent and 100 percent) and four different pressures (400 kPa, 500 kPa, 600 kPa and 700 kPa) were combined to experimentally measure the flow rate of each nozzle. Results showed that the PWM nozzles mounted in the commercial blast sprayer, under static conditions, were capable of modulating flow rate according to the duty cycle. However, the reduction of flow rates for the tested duty cycles according to pressure was lower than the percentage expected. A good linear relation was found between the pressure registered by the control system feedback sensor and the pressure measured by a reference conventional manometer located after the pump. High-speed video recordings confirmed the accurate opening and closing of the nozzles according to the duty cycle; however, substantial pressure variations were found at nozzle level. Further research to establish the general suitability of PWM systems for regulating nozzle flow rates in blast sprayers without modifying the system pressure still remains to be addressed.

Among Bemisia tabaci species, the invasive MEAM1 and MED species are key agricultural pests for many crops. In Brazil, most part of B. tabaci population outbreaks were associated with MEAM1, which, since 1990s quickly spread across the entire country. Later in 2014, the MED was identified in Brazil, initially more restricted to greenhouses, but suddenly reaching new areas in the South and Southeast open regions. Thus, our objective was to investigate the geographical distribution of MEAM1 and MED on open field crops in Brazil. MEAM1 is still the predominant species on open field crops such as soybean, cotton, and tomato. The sequencing of a cytochrome c oxidase subunit I (COI) gene fragment revealed a single haplotype of MEAM1, suggesting the establishment of a single MEAM1 strain in the country. The haplotypes found for MEAM1 and MED are genetically related to the globally dispersed strains, Jap1 and Mch1, respectively. Continuous monitoring of B. tabaci species is crucial because landscape alterations, climatic changes, and pest management methods may shift the B. tabaci species distribution and dominance in Brazilian crop areas.