Ultra-low-fouling poly[N-(2-hydroxypropyl) methacrylamide] (poly(HPMA)) brushes have been synthesized for the first time. Similar to the so far only ultra-low-fouling surface, poly(carboxybetaine acrylamide), the level of blood plasma fouling was below the detection limit of surface plasmon resonance (SPR, 0.03 ng·cm(-2)) despite being a hydrogen bond donor and displaying a moderate wettability, thus challenging the currently accepted views for the design of antifouling properties. The antifouling properties were preserved even after two years of storage. To demonstrate the potential of poly(HPMA) brushes for the preparation of bioactive ultra-low fouling surfaces a label-free SPR immunosensor for detection of G Streptococcus was prepared.

Nonspecific adsorption of proteins is a crucial problem in the detection of analytes in complex biological media by affinity sensors operating with label-free detection. We modified the gold surface of surface plasmon resonance (SPR) sensors with three types of promising antifouling coatings: self-assembled monolayers (SAM)s of alkanethiolates terminated with diethylene glycol and carboxylic groups, poly(ethylene glycol) (PEG) grafted onto the SAMs, and zwitterionic polymer brushes of poly(carboxybetaine methacrylate), poly(sulfobetaine methacrylate), and poly(phosphorylcholine methacrylate). Using SPR, we compared the efficacy of the coatings to reduce nonspecific adsorption from human blood plasma and from single-protein solutions of human serum albumin, immunoglobulin G, fibrinogen, and lysozyme. There was no direct relationship between values of water contact angles and plasma deposition on the coated surfaces. A rather high plasma deposition on SAMs was decreased by grafting PEG chains. Fouling on PEG was observed only from plasma fractions containing proteins with molecular mass higher than 350 000 Da. The adsorption kinetics from plasma collected from different healthy donors differed. Poly(carboxybetaine methacrylate) completely prevented the deposition from plasma, but the other more hydrophilic zwitterionic polymers prevented single-protein adsorption but did not prevent plasma deposition. The results suggest that neither wettability nor adsorption of the main plasma proteins was the main indicator of deposition from blood plasma.

The fouling from four human body fluids - blood plasma, cerebrospinal fluid, urine and saliva - and four animal fluids - foetal bovine and calf sera, egg and milk - relevant to human and veterinary medicine, immunology, biology and diagnostics is assessed on antifouling SAMs and on polymer brushes of oligo(ethylene glycol) methacrylate, 2-hydroxyethyl methacrylate, carboxybetaine acrylamide and N-(2-hydroxypropyl)methacrylamide synthesized via ATRP. While important deposits from the all biofluids are observed on SAMs, a superior resistance is achieved on polymer brushes. Importantly, only poly(CBAA) and poly(HPMA) are capable of resisting the fouling from the most challenging media, blood plasma and eggs.

A new route for coating various substrates with antifouling polymer layers was developed. It consisted in deposition of an amino-rich adhesion layer by means of RF magnetron sputtering of Nylon 6,6 followed by the well-controlled, surface-initiated atom transfer radical polymerization of antifouling polymer brushes initiated by bromoisobutyrate covalently attached to amino groups present in the adhesion layer. Polymer brushes of hydroxy- and methoxy-capped oligoethyleneglycol methacrylate and carboxybetaine acrylamide were grafted from bromoisobutyrate initiator attached to a 15 nm thick amino-rich adhesion layer deposited on gold, silicon, polypropylene, and titanium-aluminum-vanadium alloy surfaces. Well-controlled polymerization kinetics made it possible to control the thickness of the brushes at a nanometer scale. Zero fouling from single protein solutions and a reduction of more than 90% in the fouling from blood plasma observed on the uncoated surfaces was achieved. The feasibility of functionalization with bioactive compounds was tested by covalent attachment of streptavidin onto poly(oligoethylene glycol methacrylate) brush and subsequent immobilization of model antibodies and oligonucleotides. The procedure is nondestructive and does not require any chemical preactivation or the presence of reactive groups on the substrate surface. Contrary to current antifouling modifications, the developed coating can be built on various classes of substrates and preserves its antifouling properties even in undiluted blood plasma. The new technique might be used for fabrication of biotechnological and biomedical devices with tailor-made functions that will not be impaired by fouling from ambient biological media.

No abstract