The radiation from circular cylindrical reflector antennas is treated in an accurate manner for both polarizations. The problem is first formulated in terms of the dual series equations and then is regularized by the Riemann-Hilbert problem technique. The resulting matrix equation is solved numeridy with a guaranteed accuracy, and remarkably Little CPU time is needed. The feed directivity is included in the analysis by the complex source point method. Various characteristic patterns are obtained for the front and offset-fed reflector antenna geometries with this analysis, and some comparisons are made with the high frequency techniques. The directivity and radiated power properties are also studied. Manuscript received December 13,1993; revised August 8,1994. This work was supported in part by NATO's Scientific Affairs Division in the framework of the science for stability programme, " A K , and Telecommunications

Closed-form Green's function (CFGF) representations for cylindrically stratified media, which can be used as the kernel of an electric field integral equation, are developed. The developed CFGF representations can safely be used in a method of moments solution procedure, as they are valid for almost all possible source and field points that lie on the same radial distance from the axis of the cylinder (such as the air-dielectric and dielectric-dielectric interfaces) including the axial line (= and =), which has not been available before. In the course of obtaining these expressions, the conventional spectral domain Green's function representations are rewritten in a different form so that i) we can attack the axial line problem and ii) the method can handle electrically large cylinders. Available acceleration techniques that exist in the literature are implemented to perform the summation over the cylindrical eigenmodes efficiently. Lastly, the resulting expressions are transformed to the spatial domain using the discrete complex image method with the help of the generalized pencil of function method, where a modified two-level approach is used. Numerical results are presented in the form of mutual coupling between two current modes to assess the accuracy of the final spatial domain CFGF representations. Index Terms-Closed-form Green's functions, discrete complex image method (DCIM), generalized pencil of function (GPOF) method, method of moments (MoM).

We propose and demonstrate a wireless, passive, metamaterial-based sensor that allows for remotely monitoring submicron displacements over millimeter ranges. The sensor comprises a probe made of multiple nested split ring resonators (NSRRs) in a double-comb architecture coupled to an external antenna in its near-field. In operation, the sensor detects displacement of a structure onto which the NSRR probe is attached by telemetrically tracking the shift in its local frequency peaks. Owing to the NSRR's near-field excitation response, which is highly sensitive to the displaced comb-teeth over a wide separation, the wireless sensing system exhibits a relatively high resolution (<1 μm) and a large dynamic range (over 7 mm), along with high levels of linearity (R2 > 0.99 over 5 mm) and sensitivity (>12.7 MHz/mm in the 1–3 mm range). The sensor is also shown to be working in the linear region in a scenario where it is attached to a standard structural reinforcing bar. Because of its wireless and passive nature, together with its low cost, the proposed system enabled by the metamaterial probes holds a great promise for applications in remote structural health monitoring.

The behavior of a 2-D model of an extended hemielliptic silicon lens of a size typical for THz applications is accurately studied for the case of a plane E-wave illumination. The full-wave analysis of the scattering problem is based on the Muller's boundary integral-equations (MBIE) that are uniquely solvable. A Galerkin discretization scheme with a trigonometric basis leads to a very efficient numerical algorithm. Numerical results related to the focusability of the lens versus its rear-side extension and the angle of the plane-wave incidence, as well as near-field profiles, demonstrate strong resonances. Such effects can change the principles of optimal design of lens-based receivers.

No abstract

An elliptic-profile reflector with varying resistivity is analyzed under the illumination by an H-polarized beam generated by a complex-source-point (CSP) feed. The emphasis is done on the focusing ability that is potentially important in the applications in the optical range related to the partially transparent mirrors. We formulate the corresponding electromagnetic boundary-value problem and derive a singular integral equation from the resistive-surface boundary conditions. This equation is treated with the aid of the regularization technique called Riemann Hilbert Problem approach, which inverts the stronger singular part analytically, and converted to an infinite-matrix equation of the Fredholm 2nd kind. The resulting numerical algorithm has guaranteed convergence. This type of solution provides more accurate and faster results compared to the known method of moments. In the computations, a CSP feed is placed into a more distant geometrical focus of the elliptic reflector, and the near-field values at the closer focus are plotted and discussed. Various far-field radiation patterns including those for the non-uniform resistive variation on the reflector are also presented. © 2013 Springer Science+Business Media New York

Cataloged from PDF version of article.Accurate numerical optimization based on the rigorous\ud solution of the integral equation using the method of\ud analytical regularization is performed for the cylindrical reflector\ud antenna in a dielectric radome. It is shown that the multiple\ud scattering in this system is more significant for the optimum\ud radome design than any nonplane-wave effects or the curvature of\ud the radome. We claim that, although the common half-wavelength\ud design is a good approximation to avoid negative effects of the\ud radome (such as the loss of the antenna directivity), one can, by\ud carefully playing with the radome thickness, its radius, reflector\ud location, and the position of the feed, improve the reflector-inradome\ud antenna performance (e.g., increase the directivity) with\ud respect to the same reflector in free-space

No abstract