No abstract

No abstract

The volumetric growth, composition, and morphology of porous alumina films fabricated by reduced temperature 280 K galvanostatic anodizing of aluminum foil in 0.4, 1.0, and 2.0 M aqueous sulfuric acid with 0.5–10 mA·cm−2 current densities were investigated. It appeared that an increase in the solution concentration from 0.4 to 2 M has no significant effect on the anodizing rate, but leads to an increase in the porous alumina film growth. The volumetric growth coefficient increases from 1.26 to 1.67 with increasing current density from 0.5 to 10 mA·cm−2 and decreases with increasing solution concentration from 0.4 to 2.0 M. In addition, in the anodized samples, metallic aluminum phases are identified, and a tendency towards a decrease in the aluminum content with an increase in solution concentration is observed. Anodizing at 0.5 mA·cm−2 in 2.0 M sulfuric acid leads to formation of a non-typical nanostructured porous alumina film, consisting of ordered hemispheres containing radially diverging pores.

No abstract

The chemical dissolution—in 0.1 M solutions of phosphoric, malonic, citric, sulfosalicylic, and tartaric acids and 0.6 M solutions of sulfuric, oxalic, malonic, phosphoric, tartaric, and citric acids—of aluminum (Al) and its barrier anodic oxide, with thicknesses of 240 and 350 nm, produced during the anodization of Al deposited on a sitall substrate and Al foil, respectively, in a 1% citric acid aqueous solution, was investigated. Signs of chemical dissolution for 0.1 M phosphoric acid solution and 0.6 M concentrations of all the listed solutions were found. It was shown that the dissolution rate and the nature of its change depend on the acid nature, the state of the sample surface, and the classification of the electrolytes according to their degrees of aggressiveness with respect to aluminum.