No abstract

No abstract

Recently, the study of hybrid nanocomposites has attracted much attention because they are highly expected for being used in many applications. In this context, there is an insisting need to investigate the effect of incorporation of silica and carbon particulates nanofillers into epoxy reinforced with woven and nonwoven tissue glass fiber. The influence of incorporation of silica (SiO2) and carbon black nanoparticles (C) with different weight fractions on the tensile properties, impact strength and fatigue performance of epoxy matrix reinforced with two types of E-glass fiber was investigated. The results showed an improvement in tensile properties, impact strength and fatigue life with addition of almost all nanoparticles contents considerably with respect to that of the neat glass fiber reinforced epoxy composites (NGFRE). Hybrid composites filled with 0.5 wt.% C exhibited the highest tensile strength and fatigue performance with an enhancement of 19% and 60% compared to NGFRE, respectively. An increase of 57% and 28% in tensile modulus and impact strength over NGFRE was obtained respectively with hybrid composites filled with 1 wt.% C. Adding 0.25 wt.% SiO2 and 0.25 wt.% C simultaneously showed an improvement in mechanical properties. SEM images of tensile and impact fracture surfaces are presented for CS 0.5 specimens which in turn reveal weak fiber/matrix interface.

No abstract

This paper presents an experimental and statistical study of the fatigue behavior of unidirectional glass fiber-reinforced epoxy composite rods manufactured using pultrusion technique and modified with nanoparticles of alumina (Al2O3) and silica (SiO2) at four different weight fractions (0.5, 1.0, 2.0 and 3.0 wt.%). Tensile test was performed to investigate the influence of nanoparticles. Addition of alumina nanoparticles up to 3 wt.% increases the tensile strength by 54.76% over the pure glass fiber-reinforced epoxy specimen. For silica nanoparticles, there is an increase in the tensile strength of 31.29% for the content of 0.5 wt.% over the pure glass fiber-reinforced epoxy specimen. As the silica nanoparticles’ content increases over 0.5 wt.%, there is a decrease in the tensile strength. Rotating bending fatigue tests have been conducted at five different stress levels. Fatigue life of glass fiber-reinforced epoxy composite rods modified with alumina nanoparticles increases as the content of the nanoparticles increases. The effect of adding silica nanoparticles on the fatigue life of glass fiber-reinforced epoxy composite rods is relatively insignificant with a small improvement in the content of 0.5 wt.% silica above the pure glass fiber-reinforced epoxy specimens. Two-parameter Weibull distribution function was used to statistically analyze the fatigue life data.

This article deals with the effect of drilling parameters (feed, speed, and drill pre-wear) on the machinability parameters (thrust force, torque, peel-up and push-out delaminations, surface roughness, and bearing strength) in drilling woven glass fiber-reinforced. The results show that at high feeds (0.45 mm/rev), the drill point acts as a punch that pierces the laminate with approximately constant push-out delamination size irrespective to the value of the thrust force. Surface roughness increases with the increase of drill pre-wear due to the generated heat that assisted by the low thermal properties of polymeric composites. Drilling at high feeds reduces the stiffness of the specimens and its ultimate bearing loads. Artificial neural network and multivariable regression models were developed for predicting the bearing strength of drilled holes.

No abstract

No abstract