Zirconia Surface Treatment by Different Output Powers of Er: YAG Laser and Sandblasting: SEM Evaluation

Abstract

Background: Application of zirconia in dentistry has increased due to its good properties. Since zirconia is not possible to be etched, evaluation of the other methods of surface treatment is important. Objectives: The aim of this study was to evaluate zirconia surfaces treated by different output powers of Er: YAG laser and sandblasting technique by scanning electron microscope (SEM). Materials and Methods: 15 specimens were prepared of 3Y-TZP ceramic material. After polishing of all the samples, divided into 5 groups; control group, 1.5 W Er: YAG laser irradiated group, 2.5W Er: YAG laser irradiated group, 3.5 W Er: YAG laser irradiated and sandblasted group. Then SEM image of each group were prepared and analyzed. Results: The SEM images of study groups showed there is no significant difference between control group and laser groups at × 3000, but at the more magnifications (× 15000 and × 60000), with increasing laser power, surface roughness and deformation of crystals increases. SEM of Sandblasted group showed a change in surface texture with the formation of microretentive grooves and deformation of zirconia crystals shape. Conclusions: By increasing the Er: YAG laser power on zirconia ceramics, the surface roughness increases but not impressive. Application of sandblasting technique on zirconia provides greater surface roughness than Er: YAG laser treatment. 1.5 W (150 mJ) Er: YAG laser radiation has no significant effect on surface morphology of zirconia but 2.5 W (250 mJ) and 3.5 W (350 mJ) outputs, change the surface morphology.

The influence of air abrasion and Er,Cr:YSGG laser on shear bond strength of cubic zirconia to two resin cement types.

“…These methods include air-borne particle abrasion using alumina, laser irradiation, and tribochemical silica coating. 4,5,6,7 The question of whether surface treatment should be conducted prior to or after the sintering process remains a subject of ongoing debate among researchers. Recent research has demonstrated that pre-sintering surface treatment is an efficient and straightforward technique.…”