Untitled

<title>SnO<formula><inf><roman>2</roman></inf></formula>:Sb transparent conducting coatings made by different sol-gel processes</title>

“…The particular choice of this so! The sintering was performed in air after drying the layer at room temperature or higher temperature with heating rates varying from 0.2 to 4300 K/s using either conventional furnace heating or cw CO2 laser irradiation whose set up is described elsewhere [33,34]. The same sol was also used to obtain coatings by spray pyrolysis at T 500°C.…”

“…A comparison of the electrical parameters (resistivity p, mobility j.t, carrier density n) measured as a function of the sintering temperature is now presented for single layer coatings sintered by high power fast scan CO2 irradiation (process III, heating rate up to 7000 K/s) [33,34,40] and furnace firing (process II, heating rate 1 K/s). A comparison of the electrical parameters (resistivity p, mobility j.t, carrier density n) measured as a function of the sintering temperature is now presented for single layer coatings sintered by high power fast scan CO2 irradiation (process III, heating rate up to 7000 K/s) [33,34,40] and furnace firing (process II, heating rate 1 K/s).…”

Electrical and Optical Properties of Solution-Based Sb-Doped SnO2 Transparent Conductive Oxides Using Low-Temperature Process

“…9) 따라 서, dip-coating, spin-coating, spray pyrolysis, inkjet-printing등이 용액 기반 제조 방법으로 보고 되고 있으 며 현재까지 솔루션 기반 ATO 박막을 제조하기 위한 연 구가 진행되고 있다. [10][11][12][13] 예를 들면, Burgard등은 sol-gel spin-coating법으로 ATO 박막을 제조하였고 550 o C 열처 리 온도에서의 광학적(~90 %) 및 전기적(~37 × 10 −3 Ω•cm) 특성을 보고했다. 11) Aegerter 등은 spray pyrolysis와 dip-coating으로 제조된 ATO 박막의 특성을 비교 하였고 그 결과 spray pyrolysis로 제조된 ATO박막의 우수한 전기 적 특성(~1.5 × 10 −3 Ω•cm)을 보고했다.…”