Widely tunable DS-DBR laser with monolithically integrated SOA: design and performance

Ward, Ashley J. W.; Robbins, David J.; Busico, G.; Barton, Elizabeth J.; Ponnampalam, Lalitha; Duck, J.P.; Whitbread, N.D.; Williams, Peter J.; Reid, D.C.J.; Carter, A.C.; Wale, M.J.

doi:10.1109/jstqe.2004.841698

Cited by 230 publications

(96 citation statements)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…A commercially available Oclaro DS-DBR laser [8], which exhibited a Lorentzian phase noise of 1.4MHz (measured as in [9]), was employed as the LO in the coherent receiver. A 250MSa/s AWG generated the switching signals for the tunable laser.…”

Section: Fast Wavelength Switching Digital Coherent Receivermentioning

confidence: 99%

Fast Wavelength Switching 6 GBd Dual Polarization 16QAM Digital Coherent Burst Mode Receiver

Maher

Lavery

Paskov

et al. 2014

IEEE Photon. Technol. Lett.

View full text Add to dashboard Cite

Abstract-A commercially available digital supermode distributed Bragg reflector tunable laser is employed as a fast wavelength switching local oscillator (LO) in a dual polarization (DP) 16-quadrature amplitude modulation (16QAM) coherent burst mode receiver. A digital coherence enhancement technique is used to compensate both the Lorentzian and non-Lorentzian distributed phase noise of the tunable LO laser. It is shown that differential decoding is not sufficient to overcome the substantial bit errors caused by the LO laser phase noise. However, the coherence enhancement technique enables the reception of low symbol rate DP-16QAM bursts, with an average optical signal to noise ratio penalty of 3.5 dB observed relative to theory at the forward error correction threshold (1.5 × 10 −2 ).

show abstract

Section: Fast Wavelength Switching Digital Coherent Receivermentioning

confidence: 99%

Fast Wavelength Switching 6 GBd Dual Polarization 16QAM Digital Coherent Burst Mode Receiver

Maher

Lavery

Paskov

et al. 2014

IEEE Photon. Technol. Lett.

View full text Add to dashboard Cite

show abstract

“…Bragg reflector (DS-DBR) lasers [4]. Tunable lasers based on surface gratings have also been demonstrated, which has the cost advantages due to its simple process [5,6] compared with the conventional buried DBR based lasers.…”

Section: Introductionmentioning

confidence: 99%

Nine-Channel Wavelength Tunable Single Mode Laser Array Based on Slots

Guo

Nawrocka

et al. 2013

Cleo: 2013

View full text Add to dashboard Cite

A 9-channel wavelength tunable single-mode laser array based on slots is presented. The fabricated laser array demonstrated a threshold current in a range of 19~21 mA with the SOA unbiased at 20°C under continuous wave condition. Stable single mode performances have been observed with side-mode suppression-ratio (SMSR) > 50 dB. The output power higher than 37 mW was obtained at the SOA injected current of 70 mA for all the 9 channels within the laser array. A wavelength quasicontinuous tuning range of about 27 nm has been achieved for the laser array with the temperature variations from 10°C to 45°C. This array platform is of a single growth and monolithically integrable. It can be easily fabricated by standard photolithography. In addition, it potentially removes the yield problem due to the uncertainty of the facet cleaving.

show abstract

“…New approaches to data transmission such as coherent WDM (CoWDM (Healy, Garcia Gunning et al 2007)) require discrete tuning between particular wavelength channels on a grid. There is additionally an urgent need to integrate semiconductor lasers with other optical components such as amplifiers, modulators and detectors (Coldren 2000;Ward, Robbins et al 2005;Welch, Kish et al 2006;Raring & Coldren 2007) in order to reduce chip cost, system size and complexity. Tunable lasers are also needed in other important markets such as trace gas detection for environmental emission motoring (Phelan, Lynch et al 2005).…”

Section: Introductionmentioning

confidence: 99%

A Tunable Semiconductor Lased Based on Etched Slots Suitable for Monolithic Integration

Byrne¹,

Guo²,

Lu³

et al. 2010

Advances in Optical and Photonic Devices

View full text Add to dashboard Cite

Widely tunable DS-DBR laser with monolithically integrated SOA: design and performance

Cited by 230 publications

References 9 publications

Fast Wavelength Switching 6 GBd Dual Polarization 16QAM Digital Coherent Burst Mode Receiver

Fast Wavelength Switching 6 GBd Dual Polarization 16QAM Digital Coherent Burst Mode Receiver

Nine-Channel Wavelength Tunable Single Mode Laser Array Based on Slots

A Tunable Semiconductor Lased Based on Etched Slots Suitable for Monolithic Integration

Contact Info

Product

Resources

About