Wear analysis and prediction of the life of a riveting die used in the automotive industry

Abstract

Knowledge on the life span of the riveting dies used in the automotive industry is sparse. It is often the case that only when faulty products are produced are workers aware that their tool needs to be changed. This is of course costly both in terms of time and money. Responding to this challenge, this paper proposes a methodology which integrates wear and stress analysis to quantify the life of a riveting die. Experiments are carried out to measure the applied load required to split a rivet. The obtained results (i.e. force curves) are used to validate the wear mechanisms of the die observed using scanning electron microscopy. Sliding, impact, and adhesive wears are observed on the riveting die after a certain number of riveting cycles. The stress distribution on the die during riveting is simulated using a finite element (FE) approach. In order to confirm the accuracy of the FE model, the experimental force results are compared with the ones produced from FE simulation. The maximum and minimum von Mises' stresses generated from the FE model are input into a Goodman diagram and an S-N curve to compute the life of the riveting die. It is found that the riveting die is predicted to run for 4 980 000 cycles before failure.

Residual stress and fatigue behavior of riveted lap joints with various riveting sequences, rivet patterns, and pitches

“…The traditional detail fatigue rating model was improved and has better prediction for the fatigue reliability. Tan et al 24 proposed a methodology that integrated wear and stress analysis to quantify the life of a riveting die. The stress distribution on the die during riveting was simulated based on a FE approach.…”