Using of textured polycrystalline SbSI in actuators

Nowak, Marian; Mroczek, P.; Duka, Piotr; Kidawa, Andrzej; Szperlich, P.; Grabowski, A.; Szala, J.; Moskal, G.

doi:10.1016/j.sna.2009.01.005

Cited by 34 publications

(22 citation statements)

References 29 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…It was mentioned in (Nowak et al, 2009d) that the ultrahigh vacuum conditions (10 -8 Pa) and/or the used Al K α monochromatic radiation (with 1486.6 eV energy) could affect desorption or photodesorption of ethanol, ethoxide species, ethylene and water from the surface of sonochemically fabricated SbSI nanowires. The XPS data (Nowak et al, 2009d) revealed no such species, at least within the detection limit of the analysis. Table 10.…”

Section: Infrared Absorbance Of Sbsi Nanowiresmentioning

confidence: 99%

See 1 more Smart Citation

Photoferroelectric Nanowires

Nowak¹

2010

Nanowires Science and Technology

View full text Add to dashboard Cite

Section: Infrared Absorbance Of Sbsi Nanowiresmentioning

confidence: 99%

“…In (Nowak et al, 2009d) the XPS was used to investigate the valence band (VB) in the sonochemically prepared SbSI nanowires at room temperature under ultrahigh vacuum conditions (p=10 -8 Pa). In the XPS spectrum of the VB region of the SbSI nanowires there are two main bands (Fig.…”

Section: Type Of Majority Electric Carriers In Sbsi Nanowiresmentioning

confidence: 99%

Photoferroelectric Nanowires

Nowak¹

2010

Nanowires Science and Technology

View full text Add to dashboard Cite

“…Textured polycrystalline SbSI was used for the construction of actuators (Nowak et al 2009b). The Curie temperature of ferroelectric SbSI nanowires [T C = 292(1) K (Szperlich et al 2009)] is close to room temperature.…”

Section: Introductionmentioning

confidence: 99%

Novel piezoelectric paper based on SbSI nanowires

et al. 2017

View full text Add to dashboard Cite

A novel piezoelectric paper based on antimony sulfoiodide (SbSI) nanowires is reported. The composite of tough sonochemically produced SbSI nanowires (with lateral dimensions 10-100 nm and length up to several micrometers) with very flexible cellulose leads to applicable, elastic material suitable to use in fabrication of, for example, piezoelectric nanogenerators. For mechanical energy harvesting, cellulose/SbSI nanocomposite may be used. Due to its high values of electromechanical coefficient (k 33 = 0.9) and piezoelectric coefficient (d 33 = 1 9 10 -9 C/N), SbSI is a very attractive material for such devices. The preliminary investigations of a simple cellulose/SbSI nanogenerator for shock pressure (p = 3 MPa) and sound excitation (f = 175 Hz, L p = 90 dB) allowed to determine its open circuit voltage 2.5 V and 24 mV, respectively. For a load resistance equal to source impedance (Z S = 2.90(11) MX), maximum output power density (P L = 41.5 nW/cm 3 for 0.05-mm-thick sheet of this composite) of the cellulose/SbSI nanogenerator was observed. Cellulose/SbSI piezoelectric paper may also be useful to construct gas nanosensors and actuators.

show abstract

“…Інтерес до вивчення халькогенідних некристалічних матеріалів на основі сегне-тоелектрика SbSI [1] викликаний широки-ми можливостями їх практичного застосу-вання в системах запису інформації, опто-електроніці, інфрачервоній та нелінійній оптиці, сенсориці [2][3][4][5][6][7][8]. У цьому плані ці-кавими є стекла і композити в системі As 2 Se 3 -SbSI.…”

Section: вступunclassified