Use of numerical method for optimization of granulometric curves in eco-efficient concrete

Abstract

Concrete is the most used construction material and thus, being the cement a significant part of this material, it is also widely used around the world. Cement production is responsible for more than 5% of global CO 2 emissions, which has been continuously increasing. A solution to reduce the cement content in concretes without loss of performance is thorough the particle packing optimization. This work uses practical numerical simulations through linear programming and the modified Andreasen & Andersen model to reduce the void content of aggregate mixtures and produce concretes with superior and intermediate packing levels. A broad range of distribution modulus "q" values were tested. Deviations between the particle size distribution (PSD) curves were calculated in each step of the process. In this study, mixtures with the smallest deviations experimental PSD curves closer to the mathematical packing modeldid not present the lowest void contents. The distribution modulus "q" directly affects the fine aggregate content in the mixtures: lower q values favors higher fine aggregate contents. For concrete granular skeletons composed by sand and gravel, there is a q value below which sand is the top deviation contributor and above which gravel is the top deviation contributor. Moreover, there is a limit to the distribution modulus after which the void content of aggregate skeletons tends to increase. In this study, that was 0.30. Concretes with superior packing (S concrete) and with the lowest distribution factor (q = 0.25) showed better performance in relation to the other studied concretes, with a higher compressive strength at 91 days and with a binder intensity around 6 at 28 days and below 5 at 91 days.

Effect of polyurethane ratio on mechanical behavior of banana fiber/polyurethane-vinylester matrix composites

“…During this entire study, it was observed that, there was proper fiber pullout before specimen breaks. This seems that, there was proper fiber and matrix adhesion; consequently it completely enhances the distribution of the flexural stresses uniformly along the fiber direction before the specimen breaks [24].…”