Use of Air Cooled Condenser in Biomass Power Plants: A Case Study in Cuba

Abstract

A new project of investment developed in Cuba has 25 Biomass Power Plants (BPP) with potencies of 20 and 50 MW. The confirmed lack of water to be used in the condensers is an impediment for the project. The use of dry condensers may be a possible solution, however, the cost of the initial project and the reduction in useful power associated with its use is a limitation to consider. In order to define the feasibility of the use of ACC in these projects, a case study is carried out in which several selection criteria for investment alternatives are considered, with three other types of condensation technologies being evaluated with the objective of comparing costs of investment and operation, as well as the profits generated. The analyses were carried out for a horizon of 20 years, obtaining for the ACC uses, a pay off period of 7.6 and 8.4 years, for the facilities of 20 and 50 MW respectively. With the uses of the selection criteria for investment alternatives, was obtained that for facilities of 20 and 50 MW respectively, the Return Interest Rate (IRR) is 18.2 and 23,8 percent, the Net Present Value (NPV) (with 15% update rate) is equal to 1126.9 and 3024.0 MUSD, the cost of the life cycle is 10682.4 and 24406.1 MUSD, while, the levelized cost of electricity production is 0.062 and 0.071 USD/kWh, with a costbenefit ratio of 0.1 and 0.13. The results obtained confirm the feasibility of using ACC systems.

Biodiesel and fishmeal from Nile tilapia waste: process, techno‐economic, and Monte Carlo analyses

“…Thus, it was necessary to adjust for inflation or deflation. For this, the Marshall and Swift Cost Index (M&S) (2020) indexer was used for the price readjustment 27 …”

“…For this, the Marshall and Swift Cost Index (M&S) (2020) indexer was used for the price readjustment. 27…”

Development of expression for resistance to erosion by solid particles in turbine blades

“…Since λm and λo vary with temperature, then εc must be calculated by adding to smaller temperature intervals. A general expression for cooling strains in an n-layer system is given (Camaraza-Medina et al, 2020). Table 2 summarizes the strain ranges for each material after cooling from 540°C to room temperature, for the outer layers containing only Fe3O4, or only Fe2O3.…”

“…These maps allow visualizing the critical deformation or oxide thicknesses(d_crit )where the failure will occur, according to the specific mode expected for the combination of alloy and scale thickness. For failure in traction, there are models that describe different modes, including cracking through the scale and formation of multiple laminations, which clearly indicate the influence of scale morphology (Camaraza-Medina et al, 2020).…”

Investigation of material cost of an ethane-ethylene rectification column

“…where M&S is the Marshall and Swift cost index [-], its value was 2171.6 in 2020 (Camaraza-Medina et al, 2020). In the (12) equation D is the diameter of the column [ft], H is the height of the column [ft] and Fc is determined with the following equation:…”