Use of adhesives in manufacturing adaptronic microsystems for lightweight structures

Gesang, T.; Knäbel, H.; Maurieschat, U.; Battermann, A.; Perl, J.; Joachimi, H.

doi:10.1016/s1471-3918(00)80022-2

Search citation statements

Order By: Relevance

Paper Sections

Select...

Piezoceramic Patch Sensors1

Introduction1

Citation Types

Supporting

Mentioning

Contrasting

Year Published

2003

2014

Publication Types

Select...

Article2

Other1

Relationship

Self Cite0

Independent3

Authors

Journals

Cited by 3 publications

(2 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The structures of the two sensor types investigated are schematically shown in figures 1 and 2. The sensors with embedded piezoceramic foils and fibres of the PZT (lead-zirconate-titanate) system were developed and realized by DLR in Braunschweig and by Fraunhofer IFAM in Bremen [Ges00,Ges02], respectively. The manufacture of the PZT-foil sensors is described in more detail in an accompanying article of this issue [Wie03].…”

Section: Piezoceramic Patch Sensorsmentioning

confidence: 99%

Reliability of piezoceramic patch sensors under cyclic mechanical loading

Thielicke

Gesang

Wierach³

2003

Smart Mater. Struct.

View full text Add to dashboard Cite

show abstract

Section: Piezoceramic Patch Sensorsmentioning

confidence: 99%

Reliability of piezoceramic patch sensors under cyclic mechanical loading

Thielicke

Gesang

Wierach³

2003

Smart Mater. Struct.

View full text Add to dashboard Cite

show abstract

“…al. [8] investigated VSSP fibres in a relatively wide range of diameters between 20 µm to 250 µm. In the latter study, the piezoelectric and ferroelectric behaviour was analysed independently of the microstructure, however, it is expected that the diameter influences the development of the microstructure.…”

Section: Introductionmentioning

confidence: 99%

Influence of Fibre Diameter on the Microstructure and the Piezoelectric Properties of PZT-Fibres

Heiber¹,

Clemens²,

Graule³

et al. 2006

Advances in Science and Technology

View full text Add to dashboard Cite

Lead zirconate titanate (PZT) fibres with diameters between 70 and 300 μm have been extruded and sintered at 1200°C in a PbO-enriched atmosphere. Subsequently, the influence of fibre diameter on the microstructure (porosity and grain size) was investigated. The measurements revealed that with decreasing fibre diameter, the porosity decreases whereas the grain size increases. The influence of these microstructural differences on the piezoelectric properties was evaluated using a novel characterisation procedure for single PZT fibres. Fibres with an as-extruded diameter of 100 μm developed an average maximum strain of 3800 ppm at an applied electrical field of 3 kV/mm and exhibited the best performance for all fibres processed with the chosen sintering parameters.

show abstract