Ultra Wideband PIFA Antenna with Supporting GSM and WiMAX for Mobile Phone Applications

Jegadeesan, S.; Mansouri, Zahra; Veeramani, Arun; Zarrabi, Ferdows B.

doi:10.1109/acct.2015.111

Cited by 9 publications

(6 citation statements)

References 14 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Furthermore, PIFA gives a smaller size compared to rod, monopole and helix antenna, which lead to easier locating and alignment between the components [4]. Hence, PIFA has become a popular antenna to be used for a portable wireless device such as a mobile phone that its design widely researched concerning all the wireless communication frequency between 835 MHz and 2.6 GHz [5][6][7][8].…”

Section: Introductionmentioning

confidence: 99%

“…Nevertheless, it only considered operating frequency that less than 1 GHz, which were 900 MHz and 1800 MHz that not covering all frequencies needed for the mobile phone. A design of PIFA with greater bandwidth was deliberated in [7] to cover UWB operation across 3.1 GH -10.6 GHz. The design implemented a few slots on the patch that had a total dimension of 120 mm x 60 mm, which can be considered quite large for the use in mobile phone applications that need compact size.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Designs of rectangular-shaped planar Inverted-F antennas at mobile operating frequencies with different ground plane techniques

Razali

Seman

Chua

2019

IJEECS

View full text Add to dashboard Cite

This article presents the designs of planar inverted-F antennas (PIFAs) at frequencies of 0.835 GHz, 0.9 GHz, 1.8 GHz, 1.9 GHz, 2 GHz, and 2.6 GHz. Initially, the designs of rectangular-shaped PIFAs are determined through the parametric studies concerning the dimensions of the antenna’s patch length, shorting plate, ground plane, and substrate. Afterward, rectangular-shaped slots are introduced into radiating element of two antennas that operate at a lower frequency range of less than 1 GHz, to tune the resonant frequency to the respective 0.835 GHz and 0.9 GHz. Different configurations of partial or full ground plane are implemented to improve the reflection coefficient, S11 performance to be below -10 dB in both simulation and measurement. The proposed six PIFAs have gain that are greater than 2 dB with the nearly omnidirectional radiation patterns. All the designs and analyses are performed using the CST Microwave Studio utilizing Rogers 4003C substrate.

show abstract

Section: Introductionmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

Designs of rectangular-shaped planar Inverted-F antennas at mobile operating frequencies with different ground plane techniques

Razali

Seman

Chua

2019

IJEECS

View full text Add to dashboard Cite

show abstract

“…Furthermore, PIFA gives a smaller size compared to monopole, rod and helix antenna, which lead to easier positioning and alignment between the components [4]. Several researches on PIFA antenna for mobile phone applications are presented in [4] and [5], which ended with large size. PIFA antenna with a total large dimension of 314 x 157 mm is presented in [4] implementing a F-shaped slot that realized using RT/Duroid 5880 substrate operated at frequency of 800 MHz.…”

Section: Introductionmentioning

confidence: 99%

Design and Specific Absorption Rate of 2.6 GHz Rectangular-Shaped Planar Inverted-F Antenna

Razali¹,

Seman²,

Ishak³

2018

IJEECS

View full text Add to dashboard Cite

This article presents the investigation of specific absorption rate (SAR) of a rectangular-shaped planar inverted-F antenna (PIFA) at frequency of 2.6 GHz. Initially, the design antenna is presented with parametric study concerning the dimensions of antenna patch length, shorting plate, ground plane and substrate. The proposed PIFA antenna has -20.46 dB reflection coefficient and 2.383 dB gain. The PIFA’s SAR is correlated with the antenna gain and excitation power. The analysis shows that higher gain contributes to a lower SAR value. While, the higher excitation power causes a higher SAR value. All the design and analysis are performed using the CST Microwave Studio

show abstract

“…8 Specific absorption rate (SAR) is a factor that has been used to define the absorption ratio of electromagnetic by human body tissue. 9,10 For reducing the SAR value in the PIFA, various techniques have been developed such as designing low SAR antenna by using RF Shield, 11 PIFA with the electromagnetic band gap (EBG) structure to 0.756 W/kg for 1 g, 12 frequency selective surface (FSS) 13 and special polymers based on nanocomposite. 14 The special shape of the antenna is one of the techniques for designing the PIFA with low SAR such as meandered monopole antenna 15 or sub-ring method.…”

Section: Introductionmentioning

confidence: 99%

Split ring resonator metamaterial loads for compact Hepta band printed inverted F antenna with circular polarization

Hatami

Naser‐Moghadasi

2018

Micro & Optical Tech Letters

View full text Add to dashboard Cite

The printed inverted F antenna (PIFA) has been developed in various shapes for the wireless application. In this paper, we have developed a novel shape based on loop antenna where it is in interaction with the split ring resonator (SRR) load and the extended ground by two vias for multi‐band antenna to cover, GSM900, GSM1800, UMTS, GSM1900, WCDMA 100, 802.11b/g, LTE2600, and 802.11a/n. The antenna total dimensions are 100 mm × 60 mm and it is fabricated on a low‐cost FR‐4 substrate. The prototype antenna has omnidirectional pattern and VSWR is lower than 3 for wireless requested frequency. We obtained 2‐4 dBi antenna gain plus 70% efficiency and circular polarization at 2.5 and 5.5 GHz. The prototype antenna shows low SAR for GSM 900 and GSM 1800 while it has checked for 1 g and 10 g with maximum value of 0.942 and 1.27 W/kg for 900 and 1800 MHz, respectively. In this new survey, the SAR value is decreased sensitively as per previous range in PIFA. The prototype has simulated with HFSS and CST that we used full wave method in both simulation software and finally we compared simulation and experimental result.

show abstract

Ultra Wideband PIFA Antenna with Supporting GSM and WiMAX for Mobile Phone Applications

Cited by 9 publications

References 14 publications

Designs of rectangular-shaped planar Inverted-F antennas at mobile operating frequencies with different ground plane techniques

Designs of rectangular-shaped planar Inverted-F antennas at mobile operating frequencies with different ground plane techniques

Design and Specific Absorption Rate of 2.6 GHz Rectangular-Shaped Planar Inverted-F Antenna

Split ring resonator metamaterial loads for compact Hepta band printed inverted F antenna with circular polarization

Contact Info

Product

Resources

About