Two Step Timing Synchronization Scheme for OFDM Signal in General Purpose Processor Based Software Defined Radio Receiver

Tanaka, Yuki; Inamori, Mamiko; Sanada, Yukitoshi

doi:10.1007/s11277-014-1860-6

Cited by 1 publication

(1 citation statement)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The use of general-purpose processor (GPP) and DSPs were addressed in [22,23] and [24], respectively. However, the results show that these implementations are not power efficient for high-speed data rates.…”

Section: Development Platforms For Ofdm Transceivers: a Reviewmentioning

confidence: 99%

The implementation of the clustered‐OFDM‐based transceiver on an FPGA device: A comprehensive comparison

et al. 2021

View full text Add to dashboard Cite

Aiming at reducing hardware complexity and power consumption of multicarrier-based broadband transceivers, this contribution discusses and analyzes the implementation of clustered-orthogonal frequency division multiplexing (OFDM)-based transceiver in a field programmable gate array (FPGA) device. In this sense, several OFDM schemes covering baseband and passband data communications are implemented. The hardware resource utilization and power consumption related to each scheme, after being implemented in the FPGA device, are discussed and compared. Numerical results show that the OFDM scheme based on  (⋅)-II and (⋅)-III, which is a modified version of the hermitian symmetric (HS)-OFDM scheme, which performs both baseband and passband data communications, demands the lowest hardware resource utilization and power consumption, reducing to 1/3 the hardware resource utilization. As a result,  (⋅)-II and (⋅)-III constitute an interesting candidate for implementing new generations of high data rate, low hardware resource utilization, and low-power consumption clustered-OFDM-based transceivers for broadband data communication. Last but not least, numerical results show that the controllers used to integrate all components of a clustered-OFDM-based transceiver can demand sizeable hardware resource utilization and power consumption and, therefore, they have to be carefully designed. This is an open access article under the terms of the Creative Commons Attribution License, which permits use, distribution and reproduction in any medium, provided the original work is properly cited.

show abstract

Section: Development Platforms For Ofdm Transceivers: a Reviewmentioning

confidence: 99%