Two-Phase Numerical Modelling of a Wet Exhaust System in a Catamaran Motor Yacht Diesel Engine

CAMBAZ, Alihan; Gorgulu, Yasin Furkan; Arat, Halit

doi:10.31590/ejosat.1007351

Cited by 1 publication

(2 citation statements)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The average skewness of the generated mesh is 0.2014. Mesh quality in the range of 0 to 0.25 on the scale shared by Ansys is defined as "Excellent" [28][29][30][31][32]. The average orthogonal quality, which is the second quality indicator, is 0.79728.…”

Section: Finite Element Analysis Using Explicit Dynamicsmentioning

confidence: 99%

See 1 more Smart Citation

Estimating the Strength and Deformation Properties of the End Milling Process Using Numerical Analysis Methods

Gorgulu

Aydın

2023

Sakarya University Journal of Science

Self Cite

View full text Add to dashboard Cite

In the study, the end mill made of titanium material and having a unique design with a 4-flute was simulated during the milling of the workpiece with a geometry of a rectangular prism made of aluminum material. Ansys Explicit Dynamics was used in the study. Modeling and simulation of the milling process were made with finite element analysis for the estimation of the strength properties. The end mill is chosen as a titanium alloy, while the milled workpiece is aluminum. All parameters were kept constant and only the depth of cut was examined in three scenarios 3, 6, and 9 mm. The simulations were carried out by taking the spindle speed of 4000 RPM and the feeding rate of 3350 mm/s. One of the conveniences provided by Explicit Dynamics is that it can be solved in very small time intervals, and for this reason, the time step in the analysis is solved by taking 0.001 seconds. While hexahedral mesh is applied to the tool, a tetrahedral mesh is applied to the workpiece. The generated mesh has 8,012 nodes and 17,052 mesh elements. Average deformations for both tool and workpiece are 36.92, 38.10, and 38.29 mm, respectively. Strain also shows a similar trend to the total deformation and the average values for all three scenarios were found to be 2.84 x 10-3, 4.43 x 10-3 and 3.99 x 10-3 mm/mm. Also, the stress values were obtained as 78.23, 76.83, and 77.99 MPa.

show abstract

Section: Finite Element Analysis Using Explicit Dynamicsmentioning

confidence: 99%

“…After the start of the cutting process, the end mill cutter rotates to cut the workpiece along its length. The quality scale of these two parameters is given in Tables 1 and 2 [28][29][30][31][32]. The study done can be categorized as groove cutting and side cutting.…”

Section: Finite Element Analysis Using Explicit Dynamicsmentioning

confidence: 99%