Tuning Porous Networks in Polyimide Aerogels for Airborne Nanoparticle Filtration

Abstract

The suitability of monolithic polyimide aerogels as filter media for removal of airborne nanoparticles was investigated in this work by considering two solvents, N-methylpyrrolidone (NMP) and dimethylformamide (DMF) for tuning of meso- and macropore content. Polyimide gels were synthesized from the chemical reactions between solutions of pyromellitic dianhydride, 2,2'-dimethylbenzidine, and 1, 3, 5-triaminophenoxylbenzene. The gels were dried via supercritical drying in CO to obtain the aerogels. The porosity of polyimide aerogels was varied by changing the initial concentration of the solids in the solutions in the range of 2.5-10 wt %. The resulting aerogels show high porosity (91-98%), high specific surface area (473-953 m/g), low bulk density (0.025-0.12 g/cm), and solvent dependent macro- and mesopore content. The monoliths with bulk density of >0.05 g/cm produced high values of nanoparticle filtration efficiency (>99.95%) with air permeability of the order of 10 m. A strong proportional relationship was observed between the macropore content and air permeability and between the mesopore content and high filtration efficiency. Specimens prepared in DMF and NMP offered the same level of filtration efficiency, but the former provided a factor of 2 higher air permeability due to much greater proportion of macropores.

Review on Polymeric, Inorganic, and Composite Materials for Air Filters: From Processing to Properties

“…[180] Aerogel air filters based on modern polymers, such as polystyrene (PS) and PI, were fabricated by supercritical drying of their corresponding gels. [181,182] In addition, inorganic graphene aerogel air filters were produced by freeze drying of GO hydrogel and subsequent solvent exchange with water to carry out conventional freeze drying. [183] Inorganic hydroxyapatite (HAP) aerogel air filters were obtained by freeze drying aqueous slurries containing hydrothermally produced HAP.…”

New High-Performance Materials: Bio-Based, Eco-Friendly Polyimides

“…As a consequence, scCO2 is largely used in the production of nanoparticles, foams, aerogels, and membranes based on linear [85][86][87] or cross-linked [88][89][90][91][92] PIs. These materials have interesting features (high porosity, tunable shrinkage, nano-and micro-cavities, high surface area, ultralow dielectric constant, and mechanical resilience) that open up new possibilities in the applicability of PI-based systems such as catalytic systems, separation membranes, aviation, aerospace, construction, and others [93][94][95][96][97].…”

Photocatalytic Activity and Filtration Performance of Hybrid TiO2-Cellulose Acetate Nanofibers for Air Filter Applications

“…TiO 2 -CA nano ber webs were placed at the bottom of a sample holder on a wide-mesh metal net to support the specimen. The % penetration of sodium chloride particles passing through the TiO 2 -CA nano ber webs was determined by the relative particle concentration upstream and downstream of the sample (Zhai and Jana 2017).…”