Tribological and electrical properties of silica‐filled epoxy nanocomposites

Abstract

The tribological and electrical properties of epoxy composites filled with nano‐sized silica particles are studied and discussed in this article. To enhance the interfacial interaction between the fillers and the matrix, nanoparticles were pretreated with silane coupling agent. Dry sliding wear tests were carried out with configuration of composite sample on a rotating steel disc. Electrical measurements such as AC breakdown voltage, at 50 Hz, high voltage‐low current arc resistance and wet tracking resistance were carried out. The results reveal the influence of nanosized silica loading on wear resistance of the epoxy. It is observed that 10 wt% loading of silica is very effective in reducing the wear loss. With further increase of silica filler loading, the nanoparticles agglomerated and resulted in increase of the specific wear rate. The influence of silica particles on the specific wear rate is more pronounced under sliding wear situation. The influence of silica particle loading on epoxy is evident in the results of electrical parameters like dielectric strength, arc resistance and tracking resistance. These parameters showed improvement with filler loading up to 15 wt% and beyond this value of filler loading noticeable deterioration was observed. The effects of electrical stresses in the morphologies of the surfaces of epoxy nanocomposites are discussed. POLYM. COMPOS., 2011. © 2011 Society of Plastics Engineers

The friction and wear properties of carbon nanotubes/graphite/carbon fabric reinforced phenolic polymer composites

“…[1][2][3][4][5] When the polymer matrix must withstand high mechanical and tribological load, it is usually reinforced with various fillers, such as clay, [6] carbon nanotubes (CNTs), [7] mesoporous silica, [8] grapheme, [9] fibers, [10] or inorganic nanoparticles. [11,12] Among these reinforcing elements, fiberbased fabrics are very unique and outstanding because of their high structure ordering and tightness. Reinforcement with carbon fabric is the most preferred fabric for composites due to its interesting properties such as high specific strength, thermal conductivity, thermal and thermo-oxidative resistance, low expansion coefficient, and self-lubricity.…”

Role of Silicon Dioxide Filler on Mechanical and Dry Sliding Wear Behaviour of Glass-Epoxy Composites

“…At the normal load of 60 N and for sliding velocity of 3.14 m/s, the specific wear rate of G-E is 3.16 × 10 significantly with addition of SiO 2 as compared to unfilled G-E composites. The incorporation of hard particles like TiO 2 , SiO 2 , ZrO, SiC, and Al 2 O 3 to polymer matrix has led to better enhancement in wear resistance [13][14][15]. The improvement in wear resistance is due to the presence of fine SiO 2 particles (10 m) uniformly dispersed in epoxy matrix.…”

“…The SiO 2 particles also act as secondary reinforcement, bear the load, and reduces wear rate. Hardness contribution also plays a vital role in wear property improvement as reported elsewhere [13][14][15].…”

A study on the tribological behavior of hybrid PTFE/Kevlar fabric composites filled with nano‐SiC and/or submicron‐WS2 fillers

“…Many researchers have shown that solid lubricants and nanoparticles have great effect on the tribological properties of polymer‐matrix composites. Adding micro and nano sized fillers (SiC, Al 2 O 3 , ZnO, MoS 2 , SiO 2 , ZrO 2 , Al, TiO 2 , Cu, Pb, Ni, graphite, and carbon nanofiber) into the polymer could significant reduce the wear rate . Goyal and Yadav filled PTFE with graphite flake and found that the wear rates of 5 and 10 wt% graphite flake composites were reduced by more than 22 and 245 times, respectively, at sliding speed of 1 m/s.…”