Transmission Kikuchi diffraction study of submicrotexture within ultramylonitic peridotite

Igami, Yohei; Michibayashi, K.

doi:10.1007/s00269-021-01161-7

Cited by 4 publications

(1 citation statement)

References 28 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…However, if there are fine grains on the surface of the film, ordinary EBSD will not be effective [21,22]. Therefore, transmission Kikuchi diffraction (TKD) was developed as a derivative method of EBSD to characterize the structural information of grains of several nanometers at the micron scale [23,24].…”

Section: Introductionmentioning

confidence: 99%

Study on the fundamental factors of the property evolution of a 300 mm polycrystalline trap-rich layer

Dai

Liu

Wang

et al. 2023

Semicond. Sci. Technol.

View full text Add to dashboard Cite

The geometry and resistivity of trap-rich layer are the key parameters for 300mm trap-rich silicon-on-insulator (TR-SOI) wafers. In this paper, the evolution of warpage and resistivity of Poly-Si layers grown by atmospheric chemical vapor deposition (APCVD) with deposition temperature has been studied. The ability to quantify the surface grain size of undoped Poly-Si was evaluated among scanning electron microscopy (SEM), electron backscattering diffraction (EBSD), and transmission kikuchi diffraction (TKD). With a resolution scale of several nanometers, the fine grains on the surface of Poly-Si are accurately identified by TKD. It is confirmed that the decrease of compressive stress with deposition temperature is caused by the lower ratio of (110) grain orientation and the reduction of fine grains on the surface. However, while stress is released, the random grain boundaries (GBs) of Poly-Si will change into CSL low-Σ GBs with low recombination activity, which greatly lowers the film bulk resistivity and reduces its capacity to trap charges. Thus, a process window for the manufacturing of 300 mm TR-SOI wafers is therefore created by balancing the degradation of resistivity in the process of using deposition temperature to seek improvements in Poly-Si warpage.

show abstract