Transient process in a parallel-coupled accelerating system with regard to beam current loading

Barnyakov, A. M.; Levichev, A. E.; Nikiforov, D. A.; Chernousov, Yu. D.; Shebolaev, I. V.

doi:10.1134/s106378421501003x

Cited by 6 publications

(1 citation statement)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The purpose of the work was to develop RF modulation system for beam current control of linear electron accelerator based on parallel-coupled accelerating structure [12][13][14][15]. The requirements for the system elements are the following: minimum of RF power radiation into free space, low leakage current, minimum of coaxial-to-waveguide transfers, high breakdown strength of the elements, minimal dimensions.…”

Section: Introductionmentioning

confidence: 99%

The system of RF beam control for electron gun

et al. 2015

View full text Add to dashboard Cite

The system of RF control of three-electrode electron gun current is described. It consists of a source of microwave signal, coaxial line, coaxial RF switch and RF antenna lead. The system allows one to get the electron beam in the form of bunches with the frequency of the accelerating section to achieve the capture of particles in the acceleration mode close to 100%. The results of calculation and analysis of the elements of the system are presented. Characteristics of the devices are obtained experimentally. The results of using RF control in three-electrode electron gun at electron linear accelerator are described. KEYWORDS: Hardware and accelerator control systems; Accelerator Subsystems and Technologies; Instrumentation for particle accelerators and storage rings -low energy (linear accelerators, cyclotrons, electrostatic accelerators); Ion sources (positive ions, negative ions, electron cyclotron resonance (ECR), electron beam (EBIS))

show abstract

Section: Introductionmentioning

confidence: 99%

The system of RF beam control for electron gun

et al. 2015

View full text Add to dashboard Cite

show abstract

Development and low power test of the parallel coupled accelerating structure

et al. 2016

View full text Add to dashboard Cite

The parallel coupled accelerating structure with a frequency of 2856 MHz is described. The cavities and the power propagation efficiencies are calculated. The results of the structure tuning are described. Analysis of the measurements and comparison with calculated data are provided. On the base of the measured parameters of the parallel coupled accelerating structure the beam energy under different meanings of the current is predicted.

show abstract

Specifics of the microwave-breakdown mode in an accelerating structure with parallel coupling

Chernousov

Shebolaev

2017

Tech. Phys. Lett.

View full text Add to dashboard Cite

Transient process in a parallel-coupled accelerating system with regard to beam current loading

Cited by 6 publications

References 4 publications

The system of RF beam control for electron gun

The system of RF beam control for electron gun

Development and low power test of the parallel coupled accelerating structure

Specifics of the microwave-breakdown mode in an accelerating structure with parallel coupling

Contact Info

Product

Resources

About