Transient Modelling of Rotating and Stationary Cylindrical Heat Pipes: An Engineering Model

Abstract

Rotating wickless and stationary capillary cylindrical heat pipes are widely used heat transfer devices. Transient behavior of such heat pipes has been investigated numerically with computational fluid dynamics and lumped parameter models. In this paper, the advantages of both methods are combined into a novel engineering model that is low in computational cost but still accurate and rich in the details it provides. The model describes the interior dynamics of the heat pipe with a 2D representation of a cylindrical heat pipe. Liquid and vapor volumes are coarsely meshed in the axial direction. The cells are allowed to change in size in the radial direction during simulation. This allows for tracking the liquid/vapor interface without having to implement fine meshing. The model includes the equations for mass, momentum and energy and is applicable to both rotating and stationary heat pipes. The predictions of the model are validated with other experimental, numerical, and analytical works having an average deviation of less than 4%. The effects of various parameters on the system are explored. The presented model is suitable for the simulation of heat pipe systems in which both the level of detail and the computational cost are crucial factors.

Evaluation of High Performance Rotor Cooling Techniques for Permanent Magnet Electric Motors

“…Based on the work of Celik et al [13], the modeling of a RHP can be approximated by the equivalent thermal network in Fig. 6.…”

“…Hence, these are not discussed in detail. The thermal resistance resulting from the vapor pressure drop (R4) can be neglected since it is small [13]. The thermal resistance between the condenser external surface R7 and the heat sink will depend on the flow and heat sink properties.…”

Experimental determination of indicators of thermal state of refrigerator cars under operating conditions

“…In [5], a method for determining thermal properties in building structures is developed. The method consists of two steps of surface temperature measurement inside and outside.…”

“…The thermal resistance of insulation is determined from the comparison of the first and second measurement stages. The main drawback of this method [5] is the need to scale the surface to be tested.…”

Dynamic Modeling of the Heat Pipe-Assisted Annealing Line

“…The interior dynamics of the rotating heat pipe is described with a model derived from a previous work performed in the context of the same project [14]. The two main components of the model are the liquid and the vapor, which are modeled as lumped masses.…”