Trace moisture measurement in natural gas mixtures with a single calibration for nitrogen background gas

Abstract

The measurement and control of trace moisture is an important procedure to maintain and secure the quality and safety of pipeline systems for natural gas. The natural gas mix typically comprises methane, ethane, propane, some higher hydrocarbons, carbon dioxide and nitrogen. It is too impractical to perform additional calibrations of trace moisture measurement every time the combination of gas components in the natural gas mix is changed. This paper proposes a method to separate and compensate for the effect of the background gas composition from the trace moisture measurement by using two different frequencies in a trace moisture analyzer utilizing a ball surface acoustic wave (SAW) sensor. The experiment was performed by connecting the ball SAW trace moisture sensor to supplies of trace moisture in multiple background gases from the National Physical Laboratory (NPL) Multi-gas, Multi-pressure Standard Humidity Generator, and changing the composition of the background gases including N2, air, CH4, 80% CH4/20% C2H6, and 50% CH4/50% C2H6. At the nominal humidity frost-point values of −70 °C, −50 °C, −40 °C and −30 °C, the deviations due to the change of the background gases were within ± 1 °C in frost point.

Detection of Contaminants in Hydrogen Fuel for Fuel Cell Electrical Vehicles with Sensors—Available Technology, Testing Protocols and Implementation Challenges

“…Ball Wave Inc. has developed a moisture analyzer based on the principle of nondiffraction propagation of surface acoustic waves (SAWs). The sensor [36] consists of a spherical single-crystal α-quartz which is a piezoelectric material that converts electrical signals to mechanical vibrations and vice versa. Electrodes are manufactured on the surface of the sensor by depositing a metal thin film called an interdigital transducer (IDT).…”

A low-cost, swift response, highly sensitive MOF-based dual sensing device enables detection of ultralow humidity levels and solvent polarity changes

“…29 Out of these, capacitance-based sensors are more attractive than the other listed sensors because they are highly sensitive, operate at low cost, have fast response time, consume less power, and can be operated at room temperature. [30][31][32] Moisture-induced changes in the dielectric properties of humidity-adsorbing materials are the basis for the operation of capacitive humidity sensors. The fabrication process of capacitance-based sensors is simple and can be well integrated with the sensing material even by simple drop-casting methods.…”

Mems capacitive humidity sensors based on different structures for low humidity applications

“…[3] Among all types of humidity sensors, capacitive humidity sensors are ideal choices for modern automation systems due to low power consumption, small size, high sensitivity, linear response, and low cost. [4] The capacitive humidity sensors should strike a balance between sensitivity, response ability, and reliability. For the interdigitated structure, the initial capacitance is small but the response time is short.…”