Toward 3D Printing of Medical Implants: Reduced Lateral Droplet Spreading of Silicone Rubber under Intense IR Curing

Abstract

The direct fabrication of silicone-rubber-based individually shaped active neural implants requires high-speed-curing systems in order to prevent extensive spreading of the viscous silicone rubber materials during vulcanization. Therefore, an infrared-laser-based test setup was developed to cure the silicone rubber materials rapidly and to evaluate the resulting spreading in relation to its initial viscosity, the absorbed infrared radiation, and the surface tensions of the fabrication bed's material. Different low-adhesion materials (polyimide, Parylene-C, polytetrafluoroethylene, and fluorinated ethylenepropylene) were used as bed materials to reduce the spreading of the silicone rubber materials by means of their well-known weak surface tensions. Further, O2-plasma treatment was performed on the bed materials to reduce the surface tensions. To calculate the absorbed radiation, the emittance of the laser was measured, and the absorptances of the materials were investigated with Fourier transform infrared spectroscopy in attenuated total reflection mode. A minimum silicone rubber spreading of 3.24% was achieved after 2 s curing time, indicating the potential usability of the presented high-speed-curing process for the direct fabrication of thermal-curing silicone rubbers.

A curing model for the numerical simulation within additive manufacturing of soft polymers using peridynamics

“…Due to the fast decay of the intensity over the thickness, cf. [30], the laser irradiation is modelled as a surface effect, i.e. only particles on the surface are affected.…”

Multifunctional Silicone Rubber Nanocomposites by Controlling the Structure and Morphology of Graphene Material

“…[1]. Thus, silicone rubber finds use in high-tech applications, such as sealing, gas and aerospace industry, microfluidics, flexible electronics, medical devices, and electrical insulators, among others [2,3,4,5,6]. However, silicone rubbers usually require the use of fillers to improve their mechanical strength and stiffness.…”

Applications of α, ω‐telechelic polydimethylsiloxane as cross‐linkers for preparing high‐temperature vulcanized silicone rubber

“…High‐temperature vulcanized (HTV) silicone rubber has found tremendous success in many fields including, but not limited to, aerospace industry, electrical and electronic equipment, medical treatment, and air purification . HTV silicone rubber has found such widespread use in a wide variety of applications due to its high radiation resistance, chemical resistivity, thermal stability, and especially unique performance over a wide range of temperatures.…”