Thermo-responsive Fluorinated Organogels Showing Anti-fouling and Long-Lasting/Repeatable Icephobic Properties

Abstract

Accumulations of ice on modern infrastructures often cause severe consequences. As such, there is significant interest in developing functional coatings/surfaces that can prevent this. One such approach has been demonstrated with slippery liquid-infused porous surfaces (SLIPS) and organogels where the ice adhesion strength is reduced to the critical point (less than 10 kPa) where it can be removed by natural forces such as gravity, wind, vibrations, and so forth. However, both designs are limited by lubricant depletion. If lubricant release and reabsorption (syneresis) of organogels can be arbitrarily controlled by the surrounding temperature, the loss due to unfavorable evaporation and drainage of infused lubricants can be minimized and its durability can be extended. This study demonstrates the tunable thermo-responsive syneresis of transparent fluorinated organogels (F-ORGs) prepared from a commercial silicone elastomer and a lubricant mixture of fluorinated silicone oil and either poly(dimethylsiloxane) or poly(methylphenylsiloxane). By carefully tuning the ratio of the two lubricants in the mixture, the corresponding F-ORGs demonstrated arbitrarily tunable critical syneresis temperatures from −15 to 40 °C, below which the lubricant is released on the surface and above which the lubricant is re-absorbed. The resulting surfaces showed not only exceptionally long-lasting/repeatable low ice adhesion strengths (≤10 kPa over 50 icing/de-icing cycles) but also significant improvements in their repellency toward a variety of organic liquids. Compared to non-fluorinated organogels, F-ORGs could offer improved protection against outdoor pollutants to further enhance their practicality.

Hard Epoxy Coating with Lasting Low Ice Adhesion Strength

“…In the case of ice shedding from a uniform elastomeric coating through interfacial cavitation, τ is linked to the shear modulus ( G ), coating thickness ( l ), and ice adhesion work ( w a ) by eq ,, τ ∝ G w normala / l Decreasing w a is achieved through hydrophobic polymers, while G reduction involves lightly cross-linked rubbers or organogels (rubbers imbued with organic lubricants). However, these materials are often soft and weak, limiting practical applications. − Moreover, many reported materials display mediocre τ values ranging from 5 to 50 kPa. − …”

Durability of Slippery Liquid-Infused Surfaces: Challenges and Advances

“…These novel AmOG offer a promising solution in developing long-lasting anti-icing materials. In the literature, many stimuliresponsive organogels, which offer better functionalities when used as SLIPS, have been reported [212,213,213,214]. Organogels have emerged as a revolutionary alternative to traditional SLIPS.…”

Ice‐Shedding Endurance Enhancement of Lubricated Polyurethane NP‐GLIDE Coating Through Dual Cross‐Linking with Covalent and Hydrogen Bonds

“…Superhydrophobic coatings, [ 1–4,19–22 ] slippery liquid‐infused porous surfaces (SLIPS), [ 23 ] coatings using phase‐changing materials, [ 24 ] soft organogels, [ 11,25–28 ] photothermal coatings, [ 29 ] coatings with fracture‐controlled surfaces, [ 30 ] mechanically robust coatings with lightly‐cross‐linked surfaces, [ 13 ] and coatings with low interfacial toughness [ 31 ] have been explored for ice shedding with pros and cons for each type. For example, superhydrophobic surfaces are typically fragile and susceptible to frost, while a SLIPS tends to lose its lubricant after few icing/de‐icing cycles.…”