Thermal Spray Coatings for Electromagnetic Wave Absorption and Interference Shielding: A Review and Future Challenges

Abstract

This review aims to consolidate scattered literature on thermally sprayed coatings with nonionizing electromagnetic (EM) wave absorption and shielding over specific wavelengths potentially useful in diverse applications (e.g., microwave to millimeter wave, solar selective, photocatalytic, interference shielding, thermal barrier‐heat/emissivity). Materials EM properties such as electric permittivity, magnetic permeability, electrical conductivity, and dielectric loss are critical due to which a material can respond to absorbed, reflected, transmitted, or may excite surface electromagnetic waves at frequencies typical of electromagnetic radiations. Thermal spraying is a standard industrial practice used for depositing coatings where the sprayed layer is formed by successive impact of fully or partially molten droplets/particles of a material exposed to high or moderate temperatures and velocities. However, as an emerging novel application of an existing thermal spray techniques, some special considerations are warranted for targeted development involving relevant characterization. Key potential research areas of development relating to material selection and coating fabrication strategies and their impact on existing practices in the field are identified. The study shows a research gap in the feedstock materials design and doping, and their complex selection covered by thermally sprayed coatings that can be critical to advancing applications exploiting their electromagnetic properties.

A coral-like nano-PCF composite as a broad-bandwidth microwave absorber

“…25,26 Significant reflection loss will attenuate the incident microwaves, and the absorption strength may be extended. 27,28…”

A perspective on nanocomposite coatings for advanced functional applications

“…For a specific coating product, several factors, such as their concentration/ viscosity, how the coating is applied, the salinity of seawater, exposure to sunlight, stress corrosion cracking processes, etc., determine their released quantity (Kirchgeorg et al, 2018). Thus, developing new forms of protection against corrosion based on eco-friendlier materials with intrinsic durability, good substrate adhesion and adequate mechanical properties is key to withstand external stresses, mechanical solicitation, or weathering while minimizing the release of toxic substances during their application and operation times (Faisal et al, 2022;Teijido et al, 2022).…”

Ultra‐Broadband and Wide‐Angle Metamaterial Absorber with Carbon Black/Carbonyl Iron Composites Fabricated by Direct‐Ink‐Write 3D Printing

“…Electromagnetic metamaterials are special periodic structures which are designed and fabricated artificially; their periodic unit cell is much smaller than the wavelength of EM waves. [10][11][12] Their electromagnetic properties primarily depend on the unit structure of the metamaterials and not entirely on the intrinsic properties of the material itself. Some recent studies have reported that the EAB can be effectively widened using electromagnetic metamaterials.…”