Thermal Model Approach to Multisector Three-Phase Electrical Machines

Abstract

Multisector machines reveal a high fault-tolerant capability, since failure events can be isolated by de-energizing the faulty sector while the healthy ones contribute in delivering the required power. This paper is focused on the thermal analysis of multisector three-phase machines in healthy and faulty operations. Firstly, a 3D lumped parameter thermal network (LPTN) of a single sector is developed and fine-tuned against experimental data, through a genetic algorithm for identifying the uncertain parameters. According to the operating conditions, the varying housing surface temperature affects the heat exchanged to the ambient. Hence, an analytical formula is proposed to adjust the natural convection coefficient value depending on the operating condition. Then, the 3D-LPTN, modeling the whole machine, is built aiming at investigating the thermal behavior during faulty conditions. Finally, the complete 3D-LPTN is employed for predicting the machine thermal performance under several faulty conditions. Furthermore, the current overload experienced by the healthy sector (in order to keep the same torque level as during the pre-fault operation) is determined, in accordance with the magnet wire thermal class. The effectiveness of the 3D-LPTN in predicting the temperature is experimentally demonstrated.

Study and Active Enhancement by Converter Reconfiguration of the Performance in Terms of Stator Copper Loss, Derating Factor and Converter Rating of Multiphase Drives Under Two Open Legs With Different Stator Winding Connections

“…By using the machine thermal model, it is possible to set higher phase current than rated[43]-[45], but this requires knowledge of such model and it implies extra converter current overrating and additional complexity.2 Further explanation about the relation between |i αβ 1 | and torque can be found, e.g., in Sections 2.2 and 2.3 of[8].VOLUME 10, 2021 …”

An Investigation on the Cooling System of Synchronous Motor for Electric Buses

“…The cooling system of the motor is taken into account and the distance between cooling ducts and the distance between the ducts and the stator stack have found as most significant parameters. The paper of Zhang et al [17] studied on thermal analysis of fault-tolerant multisector machine. It is found that the machine can produce torque for 10 minutes before the winding temperature exceeds the limitation.…”

Influence of Thermal Aging on the Winding Thermal Conductivity in Low Voltage Electrical Machines

“…consumed lifetime fraction) within a generic time-interval of thermal exposure at given temperature(s). The per-unit cumulative damage experienced by an insulation system exposed to a given temperature θj for a time-span τ can be calculated according to (2).…”

“…Thermal management plays a critical part in the design and operation of electrical machines (EMs) [1][2][3]. An excellent cooling system [4][5][6] and / or the adoption of suitable materials with low thermal conductivity [7], can guarantee a) appropriate reliability levels (i.e., low failure probability) [8] and b) possibility to achieve high torque / power densities [9,10].…”