Thermal damages on the surface of a silicon wafer induced by a near-infrared laser

Abstract

Abstract. Laser-induced thermal damages of a silicon wafer surface subjected to continuous near-infrared laser irradiation were investigated. Silicon wafer specimens were illuminated by a continuous-wave fiber laser beam (1070-nm wavelength) with irradiances from 93 to 186 W∕cm 2 , and the surface morphology of each specimen was analyzed using optical microscopy. With increasing irradiance, straight cracks in the <110> direction appeared first, and partial melting and complete melting were subsequently observed. The mechanism of these laser-induced thermal damages in the silicon wafer surface was discussed with numerical analysis based on the heat transfer and thermoelasticity model. The irradiances initiating the cracking and melting were predicted by determining the irradiances in which the calculated thermal stress and temperature exceeded the corresponding limits of the fracture strength and melting point, respectively. These predictions agreed well with the experimental findings. Laser-induced thermal damages of the silicon wafer surface subjected to a continuous near-infrared laser irradiation were identified based on these investigations. © The Authors. Published by SPIE under a Creative Commons Attribution 3.0 Unported License. Distribution or reproduction of this work in whole or in part requires full attribution of the original publication, including its DOI.

Fabrication of Ge-on-insulator wafers by Smart-CutTMwith thermal management for undamaged donor Ge wafers

“…Fracture strength of the material is proportional to fracture toughness by the following relationship: σ T =K/f where K is the fracture toughness and f is the dimensional factor. Using experimental parameters (i.e., K [15] and σ T [16] of Si: 0.7 MPa•m 1/2 and 220 MPa and K [17] of Ge: 0.51 MPa•m 1/2 ), the fracture strength of Ge was calculated to be 160 MPa. Therefore, as shown in figure 3(b), any stress above 160 MPa will crack the GeOI wafer which agrees well with the experiment conditions of GeOI fabrication.…”

Towards Investigating Surface Quality of Single-Crystal Silicon Optics Polished with Different Processes

“…When silicon optics are irradiated by laser, the surface of the material absorbs the laser energy, leading to the rise in temperature. Irreversible material damage (e.g., cleavage fracture, melting, and evaporation) will occur when the laser fluence is increased to a certain level [8][9][10][11][12]. The typical damage morphology of the single-crystal silicon surface is shown in Figure 1.…”

Slip on the surface of silicon wafers under laser irradiation: Scale effect

“…[9,10] Recent researches show that slip damage is the first state of permanent damage when silicon wafers are under millisecond and continuous-wave (CW) laser irradiation. [11,12] Since slip damage happens before ablation and can easily result in fracture, it is very important to ascertain the slip mechanism.…”