The pitting susceptibility of stainless steels after a stay at open circuit in acidified chloride containing solution

Boulleret, C; Gorse, D.; Baroux, B.

doi:10.1016/0010-938x(96)00036-4

Cited by 8 publications

(3 citation statements)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…It is however worthy to notice that the pitting transients observed on Ti sulfides containing steels show not only a smaller frequency but also a different shape than those observed on MnS containing steels 4 . Therefore, an effect on the metastable pitting stage is also to be suspected.…”

Section: Effect Of Sulfide Inclusions and Sulfide Formers Alloying El...mentioning

confidence: 88%

Effect of the Metallurgical Parameters on the Relevant Electrochemical Criterion for Localized Corrosion Resistance of Stainless Steels

Baroux

Malki²

2007

ECS Trans.

View full text Add to dashboard Cite

The effects of different metallurgical factors related to the steel making process of stainless steels on their pitting corrosion resistance are investigated from the double point of view of the pitting stages and of the relevance of the electrochemical criteria currently used to compare industrial steels together in view of material selection. It is concluded that alloying elements, impurities (sulfur), cold working process and final annealing may act on all the pitting stages from pit nucleation to pit stabilization. Counting the metastable pitting transients is a relevant technique in most cases, but using pitting potential as a single criterion of pitting resistance can be misleading in the more complex situations.

show abstract

Section: Effect Of Sulfide Inclusions and Sulfide Formers Alloying El...mentioning

confidence: 88%

Effect of the Metallurgical Parameters on the Relevant Electrochemical Criterion for Localized Corrosion Resistance of Stainless Steels

Baroux

Malki²

2007

ECS Trans.

View full text Add to dashboard Cite

show abstract

“…Boulleret et al also found similar phenomenon and they proved this through the potentiosatic noise measurements. [39] Meanwhile in P1 solution with immersion time increasing the energy fractions gradually transfer to high frequency part, which reflected that the metastable pitting is gradually decay caused by the reduction of the active sites.…”

Section: En Signalmentioning

confidence: 95%

Correlated pitting stages of 304 stainless steel with recurrence quantification analysis of electrochemical noise

Zhang

2018

Materials & Corrosion

View full text Add to dashboard Cite

Pitting corrosion behavior of 304 stainless steel (SS) in ferric chloride solutions with different concentrations was investigated by morphology observation and electrochemical noise (EN) analysis. The pitting stages were related to recurrence quantification analysis (RQA) of EN. It was found that the pitting stages of 304 SS in 0.02 and 0.3 M ferric chloride solutions mainly consist of metastable pitting and stable pitting through the morphology observation and wavelet analysis of EN. Through cluster analysis for the whole RQA variables the RQA results can accurately correlate with the pitting stages. The cluster results revealed that the metastable pitting of 304SS has high recurrence rate (RR) and determinism (DET), while the stable pitting has low RR and DET.

show abstract

“…Some authors have evaluated the corrosion-resistance of stainless steels using conventional electrochemical techniques [1][2][3][4][5][6][7][8] and Electrochemical Noise Analysis (ENA) [9][10][11][12][13][14][15][16][17][18][19][20][21][22][23]. However, no report has been found that describes ENA of stainless steel and/or bulk amorphous alloys in the corrosive fuel cell environment.…”

Section: Introductionmentioning

confidence: 99%

Corrosion behavior of two bipolar plate materials in simulated PEMFC environment by electrochemical noise technique

Lafront

Ghali

Morales

2007

Electrochimica Acta

View full text Add to dashboard Cite

The pitting susceptibility of stainless steels after a stay at open circuit in acidified chloride containing solution

Cited by 8 publications

References 4 publications

Effect of the Metallurgical Parameters on the Relevant Electrochemical Criterion for Localized Corrosion Resistance of Stainless Steels

Effect of the Metallurgical Parameters on the Relevant Electrochemical Criterion for Localized Corrosion Resistance of Stainless Steels

Correlated pitting stages of 304 stainless steel with recurrence quantification analysis of electrochemical noise

Corrosion behavior of two bipolar plate materials in simulated PEMFC environment by electrochemical noise technique

Contact Info

Product

Resources

About