The morphology and gas‐separation performance of membranes comprising multiwalled carbon nanotubes/polysulfone–Kapton

Abstract

The development of desirable chemical structures and properties in nanocomposite membranes involve steps that need to be carefully designed and controlled. This study investigates the effect of adding multiwalled nanotubes (MWNT) on a Kapton-polysulfone composite membrane on the separation of various gas pairs. Data from Fourier transform infrared spectroscopy and scanning electron microscopy confirm that some studies on the Kapton-polysulfone blends are miscible on the molecular level. In fact, the results indicate that the chemical structure of the blend components, the Kapton-polysulfone blend compositions, and the carbon nanotubes play important roles in the transport properties of the resulting membranes. The results of gas permeability tests for the synthesized membranes specify that using a higher percentage of polysulfone (PSF) in blends resulted in membranes with higher ideal selectivity and permeability. Although the addition of nanotubes can increase the permeability of gases, it decreases gas pair selectivity. Furthermore, these outcomes suggest that Kapton-PSF membranes with higher PSF are special candidates for CO 2 /CH 4 separation compared to CO 2 /N 2 and O 2 /N 2 separation. High CH 4 , CO 2 , N 2 , and O 2 permeabilities of 0.35, 6.2, 0.34, and 1.15 bar, respectively, are obtained for the developed Kapton-PSF membranes (25/75%) with the highest percentage of carbon nanotubes (8%), whose values are the highest among all the resultant membranes.

Gas‐separation behavior of poly(ether sulfone)–poly(ethylene glycol) blend membranes

“…Increasing the efficiency of polymeric membranes with enhanced permeability ( P ) and selectivity is one of the most important concerns of researchers . Because common membrane materials, such as pure polymeric membranes, cannot satisfy all of the requirements for separation purposes, some methods, such as crosslinking, grafting, blending, copolymerization, and the use of inorganic nanoparticles and nanotubes, have been used to improve the gas‐separation properties of polymers . Among them, blend membranes have attracted considerable attention because blending brings about separation properties that cannot be obtained by individual polymers .…”

Monomer atomic configuration as key feature in governing the gas transport behaviors of polyimide membrane

“…In this work, N 2 permeability was also tested because it acts as the competitive gas penetrant for selectivity evaluation. Generally, N 2 is well‐known for its greater molecular sieving effect due to its larger kinetic diameter as well as lower solubility in polyimide matrix in relative to CO 2 . Hence, the observed N 2 permeability was unsurprisingly lower compared to the CO 2 permeability, with a value lower than 3.3 Barrer for all the polyimide membranes over the tested feed pressure range.…”

Pervaporation of toluene and iso‐octane through poly(vinyl alcohol)/graphene oxide nanoplate mixed matrix membranes: Comparison of crosslinked and noncrosslinked membranes

“…Nevertheless, agglomerations of nanoparticles at high loadings may reduce the void fraction of the membrane. In the literature, different nanoparticles such as carbon nanotubes, zeolites, silica, alumina, Magnesium Oxide, and TiO 2 and SiO 2 are investigated that increase the permeability of the membranes. According to the size of the channels or the interaction between nanoparticles and feed, channeling of the membrane normally leads to decreased selectivity .…”