The microstructure transformations and deformation behavior of Al-4Mg-0.2Zr alloy rolled at ambient and cryogenic temperatures

Selvan, C; Narayanan, C. Sathiya; Vigneshwaran, S.; Narayanasamy, R.; Susila, P.

doi:10.1088/2053-1591/ab3dfa

Cited by 7 publications

(1 citation statement)

References 33 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The dog bone shaped tensile specimens with a thickness of 1 mm were sliced out for the stress-strain tests from the rolled sheets in the longitudinal direction of rolling. The gauge length and width were of 6 mm and 2 mm respectively [14]. The specimens were initially polished mechanically to remove the surface irregularities to ensure the accurate determination of the tensile properties.…”

Section: Mechanical Testing and Characterizationmentioning

confidence: 99%

The dependence of the strain path on the microstructure, texture and mechanical properties of cryogenic rolled Al-Cu alloy

Selvan

Narayanan

Ravisankar

et al. 2020

Mater. Res. Express

Self Cite

View full text Add to dashboard Cite

An investigation was conducted on Al-4%Cu alloy sheets to study the role of deformation path on the strength properties, evolution of microstructure and crystallographic texture during cryogenic rolling. Samples were rolled to two distinct thickness strains (50% and 75%) by unidirectional and cross rolling (bidirectional) routes. The strength and hardness properties were found to be more efficient in the cross rolled samples at 50% reduction than their counterparts rolled unidirectionally. Dynamic recovery was observed at higher rolling reductions on cross rolling. Microscopic features observed by EBSD revealed the occurrence of significant grain refinement on the samples rolled with a change of strain path. Also, the alteration of the rolling route resulted in distinct deformation textures and microstructures. TEM studies pointed out the scattered diffusion of the disintegrated dislocation cores and the redistribution of the second phase particles on higher rolling reductions with the change of strain path. Furthermore, the texture results showed a threefold increase on the Goss/Brass ratio which indicated the good fracture toughness behaviour of the cross rolled samples at lower reductions.

show abstract

Section: Mechanical Testing and Characterizationmentioning

confidence: 99%