The mechanical properties of thermally treated 73/27 HBA/HNA copolyester

Abstract

The mechanical properties of fiber molded samples and monofilaments of thermally treated 73/27 4‐hydroxy benzoic acid/2‐hydroxy‐6‐napthoic acid (HBA/HNA) copolyester have been investigated using both tensile tests and flexural three‐point bending tests. The thermal treatment which involves step annealing at temperatures well below the degradation temperature of the 73/27 system has been shown to produce branching and crosslinking in the crystalline regions of these polymers. The flexural strength of the degraded sample decreased up to 10% of the untreated fiber molded sample. In case of tensile strength of a single fiber, the values for the degraded samples are in line with the untreated fiber in the low draw ratio region while a slight decrease in tensile strength was observed in the high draw ratio region. The decrease in flexural and tensile strength appears to result from a small amount of branching and crosslinking reactions which arise uniquely in the orthorhombic phase of the 73/27 HBA/HNA copolyester. The branching and crosslinking would prevent the molecular orientation along flow direction in the molten state. For the fiber molded samples of degraded 73/27 HBA/HNA the destruction of the chain regularity along fiber axis direction was observed by wide‐angle X‐ray diffraction. The 73/27 HBA/HNA copolyester including 1 wt% of a crosslinked oligomer was used to simulate the branching and crosslinking of the degraded 73/27 HBA/HNA copolyester. Plots of tensile strength versus draw ratio were similar for the degraded 73/27 HBA/HNA and a copolyester which included 1 wt% of a crosslinkable oligomer. Copyright © 1999 John Wiley & Sons, Ltd.

Thermal Conductivity of High-Modulus Polymer Fibers

“…In general, polymers with higher crystallinity and better chain alignment tend to have larger thermal conductivities. ,, The low thermal conductivity of Vectra is probably attributable the disorder in the chain segments; the relatively low crystallinity of ∼20% as reported in ref may also contribute to the low thermal conductivity. For LCP fibers with various chemical structures as depicted in Figure , the increase in the number of side chains in each molecular unit is likely to reduce the axial conductivity due to additional phonon scattering created by the vibrational modes of the side chains.…”

Effects of Para‐ or Meta‐Aromatic Amide Units on the Microstructure, Thermal, Mechanical, Rheological, and Dielectric Properties of Thermotropic Liquid Crystalline Poly(ester amide)s

“…One of the most commercially successful TLCPs, known as Vectra, is also a series of random copolymers synthesized from ≈75 mol% HBA and ≈25 mol% HNA monomers. [ 18–20 ] The naphthalene linkage derived from HNA monomer acts as a crankshaft, reducing the regularity of the main chain and the melting points of HBA‐based TLCPs. On the contrary, TLCPs incur high production costs primarily due to the costly monomer, HNA.…”