The Kern River Horizontal-Well Steam Pilot

A horizontal steam injection pilot project has been underway for the last four years in the Kern River heavy oil field located in the southern San Joaquin Valley of California. This pilot project was designed to address the following four prioritized learning objectives for horizontal steam injection in a mobile heavy oil reservoir, which were:What is the mechanical reliability and operability of horizontal steam injectors?Can acceptable steam conformance control along the horizontal section be achieved?Can steam conformance along the horizontal section be quantified with surveillance?What is the reservoir response and longer-term operability with horizontal steam injection? The 12-acre pilot area on the northwest flank of section 24 of the Kern River field was equipped with two horizontal steam injectors and nine vertical producing wells. The pilot area also had 12 vertical temperature observation wells (TOW) to understand steam conformance around each of the injectors and in the far-field reservoir. The TOWs were logged frequently to establish temperature trends. Based upon temperature trends steam identification and saturation logs were also acquired periodically. Five injector completions of increasing complexity were installed to understand the injectors' mechanical integrity, recovery of flow control devices, performance of isolation packers and fiber optic surveillance systems. A history-matched reservoir simulation model with coupled wellbore hydraulics was used for forecasting throughout the project life to conduct operational sensitivity analysis and to improve reservoir characterization. Fiber optic flow profiling methods were developed in the injectors that were validated with the observation wells and reservoir models. During each workover torque and drag measurements were acquired which were analyzed with both soft and stiff string analysis to understand wellbore mechanical conditions in the horizontal section. After each workover, all available reservoir and workover surveillance data, TOW logs and production and injection well information were used in a multidisciplinary review to understand progress against the four prioritized learning objectives. The performance of offsetting traditional, vertical steamflood developments were also evaluated.

show abstract

Horizontal Injection and Production Wells for EOR or Waterflooding

Taber

Seright

1992

All Days

View full text Add to dashboard Cite

This paper describes the potential benefits of using combinations of horizontal injection and production wells for EOR processes or waterflooding. Our results show that a very favorable configuration occurs when two opposed horizontal wells are drilled from injection and production wells so that the opposed laterals are parallel in the patterns, and extended until the horizontal segments almost meet midway between the like wells. Compared to five-spot patterns with vertical wells, opposed horizontal wells can increase injectivity (injection rate per applied pressure drop) by as much as a factor of ten, depending on well spacing and formation thickness. Areal sweep efficiency can be increased by 25% to 40%. The horizontal-well advantages are greatest for thin formations with wide spacing, and decline significantly for thick formations and/or close spacing. Also, for a given injection pressure, the pressure gradient in the bulk of the reservoir can average several times greater when using opposed horizontal wells than when using vertical wells. This could significantly improve microscopic displacement efficiencies for EOR processes, such as micellar/polymer flooding, that are sensitive to interfacial tensions. Because of the better sweep efficiencies, faster flooding rates, and/or lower injection pressures that are possible with horizontal wells, all EOR methods should benefit by their use. For example, polymer floods can be improved by the higher injectivity and lower rates of shear at the injection sandface. The advantages of horizontal wells for CO2 flooding include: (a) delayed CO2 breakthrough because of the better sweep efficiency, (b) the potential for maintaining the MMP in more of the reservoir with no increase in the injection pressure, (c) better injectivity at the same pressures, and (d) the opportunity to convert more pumped producers to flowing wells. Thermal EOR was not investigated in this work, but the cited references show that horizontal wells have been successful in several field applications and more projects are being planned.

show abstract

The Kern River Horizontal-Well Steam Pilot

Cited by 4 publications

References 8 publications

7. Bibliography

7. Bibliography

Design and Operational Experience with Horizontal Steam Injectors in Kern River Field, California, USA

Horizontal Injection and Production Wells for EOR or Waterflooding

Contact Info

Product

Resources

About