The influence of tool’s surface topography on mechanical properties of injection moulded product

Abstract

This publication deals with influence of tool topography (injection mould) on properties of a product. Surface of the mould was machined by various finishing technologies (milling, grinding, polishing and electrical discharge machining) which resulted in varying surface quality of the tool. The tested topography had an effect on the flow length of polymer and topographical and mechanical properties of the specimen. Examined properties (surface topography and mechanical properties) were measured in several places along the length of the product (starting at the gate and finishing at the end of the specimen). The results show that increase of the tool’s surface roughness leads to longer flow length. These findings disprove the necessity for polishing of each and every shaping part of the mould when manufacturing non-visual products. Thus, from economical and manufacturing perspective the milled or grinded tool surfaces are sufficient. Furthermore, replication of the tool’s topography is non-homogenous, which results in varying mechanical properties throughout the product. The discrepancy in mechanical properties along the length of the product is caused by differing cooling speeds in the mould. In practice, guided cooling can be used to achieve varying mechanical properties in desired places of the injected article. For example, highly stressed parts can be manufactured with the goal of having improved mechanical properties in specific places of the product. Future application of these findings poses a significant benefit for industrial practice, as it could lower the manufacturing cost of the injection mould in order of tens of percent.

Online acoustic emission measurement of tensile strength and wear rate for AA8011-TiC- ZrB2 hybrid composite

“…Porosity, also known as the void fraction, is a measure of the void or empty spaces that are present in a material. Porosity is calculated as a proportion of the volume of voids relative to the total volume of the material [15][16][17][18][19][20][21][22][23][24]. The corrosion behavior of AA8011-ZrB2 composites was investigated using an in situ approach, and the presence of ZrB2 was verified using XRD and EDS.…”