The influence of the adverse pressure gradient on the flow characteristics of a serpentine nozzle with film cooling

Hui, Zhonghao; Shi, Jingwei; Li, Zhou; Jiao, Liying; Wang, Rui; Wang, Zhanxue; Liu, Yongquan

doi:10.1016/j.ast.2023.108256

Cited by 6 publications

(1 citation statement)

References 32 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The experimental results showed that the combination of film cooling and impingement cooling could effectively reduce the temperature of the nozzle wall. Hui et al [13,14] numerically studied the effects of the structural parameters of cooling holes on the film cooling of a serpentine nozzle by using the k-ω SST turbulence model. They found that, as the inclination angle increased, the area-averaged FCE first increased and then decreased.…”

Section: Introductionmentioning

confidence: 99%

A Numerical Investigation of Film Cooling under the Effects of Different Adverse Pressure Gradients

Shi,

Hui,

Zhou

et al. 2024

Aerospace

Self Cite

View full text Add to dashboard Cite

Film cooling needs to be applied to serpentine nozzles due to an increase in thermal load. Adverse pressure gradients (APGs) near the upper wall of such nozzles hinder the forward flow of the coolant, and they may even induce a recirculation zone that complicates the cooling of the film in serpentine nozzles under different APGs. In this study, the film cooling characteristics of a serpentine nozzle under various APGs are investigated through numerical simulations. The studied pressure gradients include strong, moderate, and weak APGs. The results show that the APG weakened the adhesion of the coolant to the surface, thereby reducing the film cooling effectiveness (FCE) and the convective heat transfer coefficient (CHTC). The stronger the APG, the greater its obstructive effect. However, the recirculation zone induced by the strong APG was composed of the coolant, and it adhered tightly to the wall, thereby significantly strengthening the FCE and CHTC. The CHTC under the moderate APG significantly increased due to the convergence of two jets ejected from different holes. For the four blowing ratios, the area-averaged FCE under the strong APG was 29.8% and 24.5% higher than that under the moderate and weak APGs, while the area-averaged ratios of the CHTC under the moderate APG were 1.6% and 16.7% higher than those under the strong and weak APGs. Therefore, more holes should be arranged on the film in the zones of moderate and weak APGs.

show abstract

Section: Introductionmentioning

confidence: 99%