The Influence of Structural and Mechanical Properties of Oil on Development Parameters of Horizontal Well

Nadyrov, Aidar I.; Vladimirov, I. V.

doi:10.17122/ngdelo-2017-4-105-109

Cited by 1 publication

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In [6], it is assumed that the fast response of production wells is not associated with the technology of leveling the injectivity profile along the reservoir section, but is caused by a change in the pressure field of the area as a result of stopping and changing the operating modes of injection wells. An additional confirmation of this hypothesis is an increase in the efficiency of oil recovery with the subsequent shutdown of one of the injection wells in the area under consideration.…”

Section: Methodsmentioning

confidence: 99%

Comparison of the effectiveness of flow diverting technologies with hydrodynamic oil recovery improvement methods

Vladimirov,

Kuleshova,

Mukhametshin

et al. 2024

E3S Web Conf.

View full text Add to dashboard Cite

In this paper, two methods of increasing the efficiency of oil recovery at the final stage of development are compared - the distribution of filtration flows using various compositions and technologies, as well as changing the operating mode of the injection well to prevent the movement of the injected liquid at the most flushed intervals. Based on the use of various hydrodynamic, geological-physical and geological-statistical models, calculations related to the identification of the distribution trend of the injected liquid in a porous medium have been carried out. Using the calculation of the required indicators on various simulators, curves for the distribution of oil flow rates and product water content were constructed in dynamics depending on the permeability of reservoirs. Based on the results obtained, it is concluded that with the effective displacement of residual oil reserves within the framework of changing the dynamics of the injection well, it is necessary only to use the method of distribution of filtration flows with a decrease in productivity.

show abstract

Section: Methodsmentioning

confidence: 99%