The influence of cryogenic cooling on tool wear, dimensional accuracy and surface finish in turning AISI 1040 and E4340C steels

Dhar, Nikhil Ranjan; Paul, S.; Chattopadhyay, Angshuman

doi:10.1016/s0043-1648(01)00825-0

Cited by 111 publications

(50 citation statements)

References 12 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…This type of cooling comes with improving of surface quality and can increase the tool life [4,5]. Also the manufacturer recommends flood machining for this type of drill.…”

Section: Introductionmentioning

confidence: 99%

Analyses of process parameters influence on the drilling process by using carbide drills for steel St52-3

2017

View full text Add to dashboard Cite

Abstract. The influence of cutting parameters on the hole quality made using a new type of carbide drill, RT100 U, has been analysed experimentally and analytically. The drilling process is a common application in industrial environments and it has to be established at high accuracy and short time. The influence of process parameters (cutting speed and feed rate) on dimensional accuracy and surface roughness is analysed. The experiment was made by using external cooling and canned cycles (G81). On this experimental study was analysed the effect of feed rate onto the chip shape.

show abstract

“…This type of cooling comes with improving of surface quality and can increase the tool life [4,5]. Also the manufacturer recommends flood machining for this type of drill.…”

Section: Introductionmentioning

confidence: 99%

Analyses of process parameters influence on the drilling process by using carbide drills for steel St52-3

2017

View full text Add to dashboard Cite

show abstract

“…This clearly shows that the cost of cutting fluid exceeds the cost of cutting tool and overhead cost [5]. Meanwhile, cutting fluid also creates environmental issues and causes health injuries to humans [6,7]. Exposure of cutting fluid causes skin cancer and evaporation of cutting fluid at cutting zone is dangerous to human respiratory system [1,6].…”

Section: Introductionmentioning

confidence: 99%

“…Meanwhile, cutting fluid also creates environmental issues and causes health injuries to humans [6,7]. Exposure of cutting fluid causes skin cancer and evaporation of cutting fluid at cutting zone is dangerous to human respiratory system [1,6]. Cutting fluid cannot be used for long term as it is tend to wear out after mixing with the chips [4].…”

Section: Introductionmentioning

confidence: 99%

“…Some of the cooling method for dry machining are internally cooled, indirect cooling, solid lubricant and heat pipe technology [2,4,6,[10][11][12]. For time being, internal cooling system is the most promising cooling system to improve dry machining's performance [1,13].…”

Section: Introductionmentioning

confidence: 99%

“…For time being, internal cooling system is the most promising cooling system to improve dry machining's performance [1,13]. Indirect cooling which uses cryogen is effective but very costly [6]. Heat removal by using heat pipe is more attractive as no external flow source and external power supply is used in the cooling system [12].…”

Section: Introductionmentioning

confidence: 99%

See 2 more Smart Citations

State of art of cooling method for dry machining

et al. 2016

View full text Add to dashboard Cite

Abstract. The usage of cutting fluid in the machining operations will not only poses health risk to the workers but also creates environmental challenges associated with fluid treatment and disposal. The objective of this review paper is to identify present cooling method in dry machining and novel feature than can be included in the cooling system for a better heat removal which tend to increase machining performance. From the review study, it shows that cooling method by internal manner is most widely been researched because researcher believes that it has a promising future in adaptive machining to produce a contamination free products which supports the green manufacturing concept. The suggested novel feature is ecologically desirable and it will become as a necessity for improving the performance of dry machining in the near future.

show abstract