The Flow Field Analysis and Flow Calculation of Ultrasonic Flowmeter Based on the Fluent Software

Abstract

We can build the three-dimensional structure model based on the Gambit software and achieve the distribution of flow field in the pipe and reflux flow condition at the position of transducer in regard to the real position of transducer according to the Fluent software. Under the framework, define the reflux length based on the distance of reflux along the channel and evaluate the effect of reflux on flow field. Then we can correct the power factor with the transmission speed difference method in the ideal condition and obtain the matching expression of power correction factor according to the practice model. In the end, analyze the simulation experience and produce the sample table based on the proposed model. The comparative analysis of test results and simulation results demonstrates the validity and feasibility of the proposed simulation method. The research in this paper will lay a foundation for further study on the optimization of ultrasonic flowmeter, enhance the measurement precision, and extend the application of engineering.

Liquid Flow Measurement Using Silicone Polymer Wedge Clamp-On Ultrasonic Transducers

“…It can be seen that the ultrasonic wave travels through the flow with varying local velocities which the transducers measure as a line-average velocity [8]. This average however fails to account for the actual velocity distribution across the pipe cross section which in reality is two dimensional [21]. A flow profile correction factor (FPCF) is needed in order to accurately determine the flow velocity and therefore the mass flow rate.…”

Wax Solvent Displacement in Atoll Development Project Using Ultrasonic Devices: Case Study in the East Nile Delta in Egypt

“…The measurement principle of the fluid in a pipe in a singlepath ultrasonic flowmeter can be observed from Figure 1 [9]. The figure assumed that the diameter of the pipe is mentioned by D, ultrasonic transducers are installed on A and B sides from the pipe, which could emit and receive the ultrasonic signals, the distance between A and B represents by L, and θ is the angle of AB with the pipe axis.…”

Study on Temporal and Spatial Distribution and Transport Characteristics of Dust in New Composite Spraying Slurry

“…The concrete has a good air blocking ability and a strong compression resistance, but the dust generated in the spraying process is large, the coating rebound is large, and the transportation cost of sand, cement, and other materials is high. The fly ash filling technology often needs to arrange boreholes on the side of the roadway, which make the roadway have more cracks after filling, so the effect of blocking the air leakage is not good [11][12][13][14][15][16].…”