The effect of pulsating lubrication method on rake face cutting tool during end milling of inconel 718

Kasim, Mohd Shahir; Hafiz, M. S.A.; Ghani, Jaharah A; Izahmsah, R.; Rahman, M.N.A.; Mohamad, Wan Noor Fatihah; Mohamed, S.B.

doi:10.1016/j.rineng.2022.100764

Cited by 6 publications

(1 citation statement)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…This is because Inconel 718 has strong adhesive properties at high temperatures which cause the chips to easily adhere to the hottest area of the cutting edge [27]. According to Kasim et al [28], the area close to the depth of cut line is where the maximum force is exerted during the tool engagement with the workpiece. Thus, the cutting edge experiences the highest friction and temperature which are generated during cutting, which then results in rapid tool wear.…”

Section: Resultsmentioning

confidence: 99%

The correlation of surface roughness and tool edge condition under sustainable cryogenic machining

Halim

Haron

Ghani

et al. 2023

JMES

View full text Add to dashboard Cite

This paper investigates the correlation between surface roughness of Inconel 718 and tool edge condition of ball nose inserts when milled at high speed. The cutting parameters were varied as follows; cutting speed: 120–140 m/min, feed rate: 0.15–0.25 mm/tooth, and axial depth of cut: 0.3–0.7 mm. For a sustainable machining approach, the experimental works were carried out under a smooth supply of cryogenic coolant which is a mix of liquid CO2, gas CO2, and compressed air. The experimental results revealed that the range of surface roughness obtained is from 0.114 to 0.197 µm. Along the cutting process, the tool wear patterns such as the abrasion, chipping, and the intermittent build-up-edge near the depth of cut cause the rapid increase of tool wear as well as the roughness of the machined surface with a significant correlation between them. However, the roughness was slowly reduced and became stable with the increase of notch wear. The finding could be used as a prediction reference for monitoring surface roughness and tool wear progress under cryogenic conditions. It also provides foundations for further research on machinability under this sustainable approach.

show abstract

Section: Resultsmentioning

confidence: 99%