The Analysis of Initial Parameters of Steam in the Combined-Cycle Plant with High Temperature Gas Turbine

Abstract

Abstract. Presents the results of studying the influence of initial steam parameters on the thermal efficiency of double-circuit combined-cycle plant based on a powerful hightemperature gas turbines of the last generation. The advantages of double-circuit combinedcycle plant without reheat in comparison with more complex schemes. Found optimal thermal efficiency values of initial parameters of steam.

Effective fuel temperature of WWER-1000

“…Safety operation of nuclear power plants is the reliability and efficiency of the individual components: staff, heat transfer equipment [1][2][3][4][5][6], characteristics of nuclear fuel [7] and many others.…”

Research of rheological properties improvement methods of coal-water fuel based on low-grade coal

“…The problem solution of catching the sulphur dioxide and nitrogen oxides out of the flue gases from the thermal power plants is connected with the processing of large volumes of gas emissions, exceeding in some cases million cubic meters per hour [1][2][3][4]. As a rule, highquality power plant coals produced in the Russian Federation are exported abroad.…”

Technical and economic analysis of the combined-cycle plant with back-pressure steam turbine

“…The exhaust heat of gas turbine (GT) is recovered in a heat recovery steam generator (HRSG) for generation of superheated steam, which then flows to the steam bottoming cycle. The efficiency of these CCGTs based on high-temperature GT reaches 60% and higher [6,7]. Higher levels of heat efficiency are obtained in cogeneration combined-cycle plants supplied with different cycles and circuits.…”