Termografia Aktywna Jako Nowoczesna Metoda Badań Elementów Żelbetowych

Noszczyk, Paweł; Nowak, H.

doi:10.7862/rb.2016.211

Cited by 1 publication

(1 citation statement)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The image sequence may be analyzed in the time domain or in the frequency domain. Since it is more difficult to detect inclusions in large-sized and massive members, they are less often investigated using this method [20,21,22,23,24,25,26,27,28,29,30,31,32,33,34,35,36,37,38,39,40,41,42,43,44,45,46,47,48]. No experiment in which the time of recording thermograms is considerably extended until a thermal equilibrium between the tested element and the environment is reached.…”

Section: Introductionmentioning

confidence: 99%

Inverse Contrast in Non-Destructive Materials Research by Using Active Thermography

Noszczyk

Nowak

2019

Materials

Self Cite

View full text Add to dashboard Cite

Background: it is undesirable for defects to occur in building partitions and units. There is a need to develop and improve research techniques for locating such defects, especially non-destructive techniques for active thermography. The aim of the experiment was to explore the possibility of using active thermography for testing large-sized building units (with high heat capacity) in order to locate material inclusions. Methods: as part of the experiment, two building partition models—one made of gypsum board (GB) and another made of oriented strand board (OSB)—were built. Three material inclusions (styrofoam, granite, and steel), considerably differing in their thermal parameters, were placed in each of the partitions. A 7.2 kW infrared radiator was used for thermally exciting (heating) the investigated element for 30 min. The distribution of the temperature field was studied on both sides of the partition for a few hours. Results: using the proposed investigative method, one can detect defects in building partitions under at least 22 mm of thick cladding. At a later cooling down phase, inverse temperature contrasts were found to occur—the defects, which at the beginning of cooling down were visible as warmer areas, at a later phase of cooling down are perceived as cooler areas, and vice versa (on the same front surface). In the transmission mode, the defects are always visible as areas warmer than defect-free areas. Moreover, a quantitative (defect location depth) analysis with an accuracy of up to 10% was carried out using the Echo Defect Shape method. Conclusions: active thermography can be used in construction for non-destructive materials testing. When the recording of thermograms is conducted for an appropriate length of time, inverse contrasts can be observed (on the same front surface).

show abstract