Abstract. The paper considers an electromechanical surfacing technique of parts’ work surfaces. It was found out that depending on strain temperature, rate and degree there were special type structures formed on a surface layer with a phase change (a bright layer), i.e. a hot deformed structure with and without recrystallization and a cold deformed structure. Depending on the original structure and hardening conditions, during surfacing of parts a thickness of this area may achieve 0.3 mm max. Impact of steel electromechanical treatment on the structure and the surface layer was found out. Depending on properties of surfaces being treated it is possible to use plate-like and roller-type tools for electromechanical hardening. It was shown that roller- type tools possessed enhanced durability and enlarged areas of surfaces being treated, though ensured poorer finish of surfaces being treated.