Synthesis and crystal growth of the europium doped BaF2 - BaCl2 system

Wiggins, Brenden; Richards, Cameron G.; Volpi, Azzurra; Williams, D.; Iliev, Metodi; Hehlen, Markus P.

doi:10.1016/j.jcrysgro.2019.125431

Cited by 5 publications

(1 citation statement)

References 11 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In the traditional scintillator, in addition to the above‐mentioned materials, there are many excellent scintillator materials, such as binary halide scintillator, [ 103–110 ] fluoride, [ 111–113 ] and we call these materials as other scintillator materials. Among them, binary halide scintillators, NaI and CsI single crystals, doped with Tl, are the earliest developed scintillator material systems.…”

Section: Scintillator Materialsmentioning

confidence: 99%

Halide Perovskite, a Potential Scintillator for X‐Ray Detection

et al. 2020

View full text Add to dashboard Cite

the coincidence efficiency. This indicates that the solid angle controlled by the PET system and the efficiency of the intrinsic detector are greater. [11,12] More significantly, the Compton events in the pulse height spectrum are mainly caused by scattering in the scintillator. Therefore, these deficiencies can be avoided by lowering the threshold. However, the signal provided by Compton scattering quanta in adjacent crystals may be higher than the threshold, and thus may affect the position resolution and make it worse. In X-ray computed tomography (CT), the body is mainly irradiated continuously from multiple directions by fan-shaped X-rays, while attenuation profiles are recorded, and finally reconstructed from the cross-sectional view of the body. [13] This technology mainly uses complex scanning methods in the field of clinical practice. At present, the realized way of X-rays detector can be roughly divided into two types, direct and indirect. The former one directly absorbs incident X-rays, generates electronic signals through semiconductors or engenders chemical signals through thin films. [14-17] This method can directly convert X-rays into visible light without going through other processes. Therefore, an X-ray detector with a wide linear response range, fast pulse rise time, high-energy resolution, and spatial resolution can be obtained, which makes it copiously applied in X-ray detection. [18-21] However, X-ray detectors based on semiconductors face the challenges of high cost and low efficiency. In addition, although the film is cheap, it is difficult to apply in digital form, which may limit its further development. The latter one refers to the conversion of X-rays (in the highenergy radiation, in addition to X-rays, α, β, and γ rays are also included) into ultraviolet visible (UV) light through scintillators which can be further captured by optical devices. [22-24] It consists of a scintillator and an array photodiode (PD). In contrast, since the scintillator that converts X-rays indirectly is cheap, it is easier to implement in the industry than direct detectors, and has the characteristics of low cost and abundant options, stability, and flexible conversion rate. [25,26] At present, indirect X-ray detectors are widely used in ordinary flat panel X-ray detectors. Moreover, it can be flexibly combined with commercially mature sensor arrays (e.g., amorphous silicon PDs, thin film transistor arrays, photomultiplier tubes, complementary metal oxide semiconductors, silicon avalanche PDs, and X-ray imaging charge-coupled devices [CCD]), therefore, they have attracted more attention. Scintillator is a unique class of luminescent materials, which is extensively used in many fields such as nondestructive testing, medical imaging, space probes, etc. Compared with the disadvantages of traditional scintillator materials which have high cost, are fragile, have long response time and low spatial resolution disadvantages, metal halide perovskites are considered to be the most potential scintillator materials in ...

show abstract

Section: Scintillator Materialsmentioning

confidence: 99%