Superdeep vertical seismic profiling at the KTB deep drill hole (Germany): Seismic close‐up view of a major thrust zone down to 8.5 km depth

Abstract

[1] The lowermost section of the continental superdeep drill hole German Continental Deep Drilling Program (KTB) (south Germany) has been investigated for the first time by vertical seismic profiling (VSP). The new VSP samples the still accessible range of 6-8.5 km depth. Between 7 and 8.5 km depth, the drill hole intersects a major cataclastic fault zone which can be traced back to the Earth's surface where it forms a lineament of regional importance, the Franconian line. To determine the seismic properties of the crust in situ, in particular within and around this deep fault zone, was one of the major goals of the VSP. For the measurements a newly developed high-pressure/high-temperature borehole geophone was used that was capable of withstanding temperatures and pressures up to 260°C and 140 MPa, respectively. The velocity-depth profiles and reflection images resulting from the VSP are of high spatial resolution due to a small geophone spacing of 12.5 m and a broad seismic signal spectrum. Compared to the upper part of the borehole, we found more than 10% decrease of the P wave velocity in the deep, fractured metamorphic rock formations. P wave velocity is $5.5 km/s at 8.5 km depth compared to 6.0-6.5 km/s at more shallow levels above 7 km. In addition, seismic anisotropy was observed to increase significantly within the deep fracture zone showing more than 10% shear wave splitting and azimuthal variation of S wave polarization. In order to quantify the effect of fractures on the seismic velocity in situ we compared lithologically identical rock units at shallow and large depths: Combining seismic velocity and structural logs, we could determine the elastic tensors for three gneiss sections. The analysis of these tensors showed that we need fracture porosity in the percent range in order to explain seismic velocity and anisotropy observed within the fault zone. The opening of significant pore space around 8 km depth can only be maintained by differential tectonic stress combined with intense macroscopic fracturing. VSP reflection imaging based on PP and PS converted reflected waves showed that the major fault system at the KTB site is wider and more complex than previously known. The so-called SE1 reflection previously found in two-and three-dimensional surface seismic surveys corresponds to the top of an $1 km wide fault system. Its lower portion was not illuminated by surface seismic acquisition geometry. VSP imaging shows that the fault zone comprises two major and a number of smaller SE dipping fault planes and several conjugate fracture planes. The previously recognized upper fault plane is not associated with a strong velocity anomaly but indicates the depth below which the dramatic velocity decrease starts. Regarding the complexly faulted crustal section of the KTB site as a whole, we found that fluctuation spectra of rock composition and seismic velocity show similar patterns. We could verify that a significant amount of P wave energy is continuously converted into shear energy by forward scattering a...

Local regularity analysis of strata heterogeneities from sonic logs

“…At each point z 0 , the pointwise Hölder exponent is almost surely equal to its Hurst exponent H (z 0 ) (Peltier and Lévy-Véhel, 1995;Benassi et al, 1997). Thus, a nhBm allows to describe phenomena whose regularity varies in space (or in time).…”

“…The analyzed part is the stochastic component s(z), also called fractional fluctuation (Shiomi et al, 1997;Zaourar et al, 2006a), given by:…”

“…The estimation of the local Hurst parameter of a nhBm process {X(j ),0 ≤ j ≤ n} of (n+1) samples is given by Peltier Algorithm (PA) (Peltier and Lévy-Véhel, 1995): where S k,n (i) is the local growth of the increment process…”

“…The logs are modeled as nhBm processes using the approach suggested by Peltier and Lévy-Véhel (1995). A nhBm path is generated by simulating N fBms with the parameters H (i), i = 1,...,N, and constructed by setting:…”

Initial seismic observations from a deep borehole drilled into the Canadian Shield in northeast Alberta

“…Detailed borehole seismic surveys have been carried out at Kola (Pavlenkova 1992;Carr et al 1996;Ganchin et al 1998), KTB (Li and Richwalski 1996;Lüschen et al 1996;Harjes et al 1997;Okaya 2004;Rabbel et al 2004), and Outokumpu (Duo 2011;Heinonen et al 2011;Kukkonen et al 2012;Schijns et al 2012). Surveys in similar crystalline lithologies but in more tectonically active zones include studies at Soultzsous-Forêts, France (Place et al 2011), and Cajon Pass, California (Rector 1988), for mineral exploration (e.g., Miao et al 1994;Eaton et al 1996), and for repository characterization (e.g., Cosma et al 2001).…”