Study on the Process and Mechanism of Rolling-Bonding between Magnesium and Aluminum

Wang, Qun Jiao; Le, Qi; Chen, Jin Geng; Cui, Jian Zhong

doi:10.4028/www.scientific.net/msf.546-549.467

Cited by 4 publications

(2 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Nevertheless, some studies concluded that, the inter-metallic phases do not weaken the bonding strength when the thickness of this layer does not exceed a critical thickness [9]. Compared to the other dissimilar roll bonded metals, few studies were conducted to investigate the influence of heat treatment on the roll bonded Al/Mg material properties [10,11]. Focussing primarily on the mechanical properties of heat treated Al/Mg roll bonded material, the bonding strength was not studies [10][11].…”

Section: Introductionmentioning

confidence: 99%

“…Compared to the other dissimilar roll bonded metals, few studies were conducted to investigate the influence of heat treatment on the roll bonded Al/Mg material properties [10,11]. Focussing primarily on the mechanical properties of heat treated Al/Mg roll bonded material, the bonding strength was not studies [10][11]. Thus, little is known about the mechanism of the inter-metallic layers generation as well as a systematic analysis of the effects of annealing parameters on improving overall bonding strength, mechanical properties and formability of the Al/Mg laminated composites.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Effect of Inter-Metallic Phases on the Bonding Strength and Forming Properties of Al/Mg Sandwiched Composite

Saleh

Reichelt

Schmidtchen

et al. 2014

KEM

View full text Add to dashboard Cite

Composite sheet of Twin Roll Cast (TRC) AZ31-Mg alloy and industrial pure Al-1050 was fabricated as Al/Mg/Al with a hot roll bonding process. As the diffusion zone at the interface between the layers plays a crucial role in the formation of bonding strength and formability of clad sheets. It is important to describe the processes of inter-diffusion layer generation in order to assess the abilities of the laminate composites for further processing. Thus, the aim of this study was to investigate the development of the bonding strength, microstructure and mechanical properties of the bonding interface directly after roll bonding and additionally post-annealing processes. Microstructure characterization techniques such as optical and scanning electron microscopy including energy dispersive X-ray analysis (EDX) were applied to investigate the bonding area. No inter-metallic phases were present directly after the roll bonding process. The creation and growth of Al2Mg3 and Al12Mg17 phases were apparent after annealing at temperatures of 250 to 400 °C at different times ranging from five to 120 minutes. The results prove that the growth rate of inter-metallic phases increases considerably with an increase in the annealing temperature. The micro-hardness of the interface-area was also investigated. It was observed that the two inter-metallic phases were significantly harder than the substrate Mg and Al. In order to examine the influence of the inter-metallic phases on the resulting bonding strength after the annealing process, the shear bonding strength test has been conducted for different samples that were annealed at different heat treatment conditions. The results indicate that the optimum annealing temperature is 200 °C leading to a maximum bonding strength. Moreover, the mechanical properties of the composite after roll bonding and post annealing were determined by means of room temperature tensile test. The fracture mechanism after tensile test was also discussed.Keywords:Rollbonding,Al/Mghotrollbonding,TwinrollcastAZ31,bondingstrength

show abstract

Section: Introductionmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%