Study on the additional support length requirements of single-span bridges due to skew using a simplified method

Abstract

Skew bridges with seat-type abutments are frequently unseated in earthquakes due to large transverse displacements at their acute corners. It is believed these large displacements are due to in-plane rotation of the superstructure. Lack of detailed guidelines for modeling of skew bridges, many current design codes give empirical expressions rather than theoretical solutions for the additional support length required in skew bridges to prevent unseating. In this paper, a parametric study has been carried out to study the influence of skew angle, aspect ratio and fundamental periods of bridges on the additional support length requirements of single-span bridges due to skew using a shake table experiment validated Simplified Method, which is capable of simulating gap closure based on response spectrum analysis. This method is developed based on the premise that the obtuse corner of the superstructure engages the adjacent back wall during lateral loading and rotates about this corner until the loading reverses direction. A design response spectrum specified in AASHTO LRFD Specifications was employed to represent the design-level earthquakes. The results show the additional length required to prevent unseating due to skew increases with the skew angle in an approximately linear manner when the angle is less than a critical value and decreases for angles above this value. This critical skew angle increases with the aspect ratio approximately in a linear manner and shows negligible dependence on the fundamental periods of the bridges, and combination of span length and width. In addition, the critical skew angle varies between 58° and 66°, when the aspect ratio is varied from 3.0 to 5.0. The results also show that the empirical formulas for minimum support length requirements of skew bridges in current codes and specifications can not accurately reflect the influence of skew.