Study on Pyroelectric Harvesters Integrating Solar Radiation with Wind Power

Abstract

Pyroelectric harvesters use temperature fluctuations to generate electrical outputs. Solar radiation and waste heat are rich energy sources that can be harvested. Pyroelectric energy converters offer a novel and direct energy-conversion technology by transforming time-dependent temperatures directly into electricity. Moreover, the great challenge for pyroelectric energy harvesting lies in finding promising temperature variations or an alternating thermal loading in real situations. Hence, in this article, a novel pyroelectric harvester integrating solar radiation with wind power by the pyroelectric effect is proposed. Solar radiation is a thermal source, and wind is a dynamic potential. A disk generator is used for harvesting wind power. A mechanism is considered to convert the rotary energy of the disk generator to drive a shutter for generating temperature variations in pyroelectric cells using a planetary gear system. The optimal period of the pyroelectric cells is 35 s to harvest the stored energy, about 70 μJ, while the rotary velocity of the disk generator is about 31 RPM and the wind speed is about 1 m/s. In this state, the stored energy acquired from the pyroelectric harvester is about 75% more than that from the disk generator. Although the generated energy of the proposed pyroelectric harvester is less than that of the disk generator, the pyroelectric harvester plays a complementary role when the disk generator is inactive in situations of low wind speed. OPEN ACCESSEnergies 2015, 8 7466

Lead‐Free Pyroelectric Materials for Thermal Energy Harvesting: A Comparative Study

“…Moreover, further contributions can occur through thermally stimulated currents . Such systems are close to real‐time applications and have been used to investigate energy harvesting possibilities using pyroelectric materials and are therefore used in this investigation. Figure shows the measured temperature variation near the surface of sample as a function of time for a constant frequency (heating/cooling cycles) (taken at various frequencies and shown only at 0.06 Hz).…”

Diesel Exhaust Emission Soot Coated Pyroelectric Materials for Improved Thermal Energy Harvesting

“…A Phillips IR lamp (250 W) and a water block were used to generate temperature fluctuations across the upper surface of coated and uncoated samples. Similar setups were close to real time applications and were explored by several researchers . The sample was heated by switching the lamp ON and OFF from 1 to 5 s by placing it 1 cm away from the sample, while it was continuously cooled through water flow (25 °C) below its surface.…”

Large Gain in Pyroelectric Energy Conversion through a Candle Soot Coating

“…The output from such setup was not so accurate because the sample may not be uniformly exposed to heating. However, such kinds of setup has also been used previously and the results from such setup will be closer to real time application …”