Study of the Influence of Cutting Edge on Micro Cutting of Hardened Steel Using FE and SPH Modeling

Abstract

Micromachining allows the production of micro-components with complex geometries in various materials. However, it presents several scientific issues due to scale reduction compared to conventional machining. These issues are called size effects. At this level, micromachining experiments raise technical difficulties and significant costs. In this context, numerical modeling is widely used in order to study these different size effects. This article presents four different numerical models of micro-cutting of hardened steel, a Smooth Particle Hydrodynamics (SPH) model and three finite element (FE) models using three different formulations: Lagrangian, Arbitrary Eulerian–Lagrangian (ALE) and Coupled Eulerian–Lagrangian (CEL). The objective is to study the effect of tool edge radius on the micro-cutting process through the evolution of cutting forces, chip morphology and stress distribution in different areas and to compare the relevance of the different models. First, results obtained from two models using FE (Lagrangian) and SPH method were compared with experimental data obtained in previous work. It shows that the different numerical methods are relevant for studying geometrical size effects because cutting force and stress distribution correlate with experimental data. However, they present limits due to the calculation approaches. For a second time, this paper presents a comparison between the four different numerical models cited previously in order to choose which method of modeling can present the micro-cutting process.

Simulation and Experimental Analysis of Surface Defects in Turning of TiCp/TC4 Composites

“…For the PCD tool assembly, the tool rod model is PSSNR2020K12. According to Figure 5 , the PCD tools [ 28 ] selected are a mixture of 30 and 2 μm diamonds. Table 5 displays the specific PCD tool parameters.…”

Multi-objective optimization of cutting parameters for efficient and high-quality in milling gray cast iron HT250

“…The finite element simulation technology has become an important means to study the cutting process and mechanism due to rapid development of computer and finite element technology [8][9][10] . However, the research on optimization of cutting parameters currently relies on traditional physical cutting experiments.…”

Development of a quick-stop device for micro-cutting

“…Another means of investigation to identify local phenomena is to abruptly interrupt the cut to freeze and then observe the formation of the chip by suitable means (SEM, EDX, EBSD) in order to confirm hypotheses [4]. This technique, which has been tried and tested on a conventional scale, is rare on a micro-machining scale.…”