Study of mechanical properties of C-Mn-Si composition metal after wire-arc additive manufacturing (WAAM)

Abstract

Wire-arc additive manufacturing (WAAM) is considered as a rather promising alternative to conventional subtracting production process for manufacture of large expensive metal components with complicated geometrical shape. Up-todate direction of WAAM investigations is aimed on production of functional metallic components with complicated geometrical shape and high accuracy, surface processing and mechanical properties meeting the strict requirements of aerospace, automotive and instrumental industries. At the same time, structural application of metal components based on their mechanical properties is studied insufficiently. It is necessary to understand additionally influence of technological conditions (such as energy input, protective gas role, speed of wire feed, welding speed, facing features and its sequence etc.) on the thermal initial parameters and finishing mechanical properties. The paper displays that mechanical properties of low-alloyed silicon-manganese composition of C-Mn-Si type with ferrite-pearlite structure is higher comparing with conventional steel 09G2S. It is shown that impact strength values for C-Mn-Si-type composition, which id formed via WAAM method, is higher by 2 times in comparison with welded joints which are faced by Sv-08G2S wire.

Diagnostics and reliability of current receivers

“…As can be seen from the table, the largest number of faults is associated with the deformation or breakage of structural elements of current collectors [4]. Reasons for deformation and breakage of pantograph frame structures [5,[13][14][15]: Constructive imperfection of the current collector unit of the pantograph;…”

Improving the efficiency of reactive power compensation devices through neural analysis

“…For simplicity of experiment and exact selection of signal delay level, the number of neural layers and neurons, we will give all parameters in relative units [7,19,20]. To display the correctness of neural network operation, we will display in Figure 1 operating mode before deep melting of metal in the bath of an arc steel furnace [15][16][17].…”

Analysis of the technology for increasing the recovery and intensification of hydrocarbon production

“…Seawater and produced water are treated, respectively, in separate seawater and produced water treatment plants [19][20][21].…”