Studies the Influence of Pulsed Current and Activated Flux with TIG Welding on the Microstructure and Mechanical Properties of Stircasted Al-SiC Composite

Sivachidambaram, P.; Balachandar, K.

doi:10.17485/ijst/2015/v8i27/71559

Search citation statements

Order By: Relevance

Paper Sections

Select...

Introduction1

Citation Types

Supporting

Mentioning

Contrasting

Year Published

2017

2019

Publication Types

Select...

Article3

Relationship

Self Cite0

Independent3

Authors

Journals

Cited by 3 publications

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The process, because it allows an independence in the rate of material fed with the heat supplied to the workpiece, allows a broad control of the aspects that contribute to a weld with high metallurgical quality, such as penetration control, wettability, dilution, etc. [11].…”

Section: Introductionmentioning

confidence: 99%

Contributions of the High Frequency Dynamic Wire Feeding in the GTAW Process for Increased Robustness

Silva

Schwedersky

et al. 2019

Soldag. insp.

View full text Add to dashboard Cite

Section: Introductionmentioning

confidence: 99%

Contributions of the High Frequency Dynamic Wire Feeding in the GTAW Process for Increased Robustness

Silva

Schwedersky

et al. 2019

Soldag. insp.

View full text Add to dashboard Cite

Novel cascaded H-bridge sub-multilevel inverter with reduced switches towards low total harmonic distortion for photovoltaic application

Babu

Raghavendiran²,

Sivachidambaranathan

et al. 2017

International Journal of Ambient Energy

View full text Add to dashboard Cite

Effects of Al–8.5Si–25Cu–xY filler metal foils on vacuum brazing of SiCp/Al composites

Jin-feng³

et al. 2018

Materials Science and Technology

View full text Add to dashboard Cite

Rapidly solidified Al–8.5Si–25Cu– xY (wt-%, x = 0, 0.05, 0.1, 0.2, 0.3, 0.4, and 0.5) foils were used as filler metal to braze Al matrix composites with high SiC particle content (SiCp/Al-MMCs), and the filler presented fine microstructure and good wettability on the composites. The joint shear strength first increased, then decreased and a sound joint with a maximum shear strength of 135.32 MPa was achieved using Al–8.5Si–25Cu–0.3Y as the filler metal. After Y exceeded 0.3%, a needle-like intermetallic compound, Al3Y, was found in the brazing seam, resulting in a dramatic decline in the shear strength of the brazed joints. In this research, the Al–8.5Si–25Cu–0.3Y filler metal foil was found to be suitable for the brazing of SiCp/Al-MMCs with high SiC particle content.

show abstract

Studies the Influence of Pulsed Current and Activated Flux with TIG Welding on the Microstructure and Mechanical Properties of Stircasted Al-SiC Composite

Cited by 3 publications

References 0 publications

Contributions of the High Frequency Dynamic Wire Feeding in the GTAW Process for Increased Robustness

Contributions of the High Frequency Dynamic Wire Feeding in the GTAW Process for Increased Robustness

Novel cascaded H-bridge sub-multilevel inverter with reduced switches towards low total harmonic distortion for photovoltaic application

Effects of Al–8.5Si–25Cu–xY filler metal foils on vacuum brazing of SiCp/Al composites

Contact Info

Product

Resources

About